Hi,
I use the nrf51422 chip.I want to know if the ANT establish link between chips,where can I get the matching configuration (like device type、channel ID).I mean is...
Is there a way to recieve more than one write callback for a given characteristic, per radio session? It seems like I can rx 1 time per attribute per radio session and tx...
If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
I have written two methods to read and write value from fds.I get FDS_EVT_WRITE call back with p_fds_evt->result=!= FDS_SUCCESS
but when i try to read it after that it gives...
Hello,
I use the method, armgcc.
The commends "make flash_softdevice" and "make flash" echo the below. It seems OK. But I cannot see the app "/nRF5_SDK_12.3.0_d7731ad...
Hi,
I'm having a bit of a problem with using friend nodes in mesh networks. I have connected a friend for 2 nodes:
1, But I do not understand the real mechanism of the...
Hi,
I am trying to receive data using USB Custom HID.
Data reception is normal using "app_usbd_hid_generic_out_report_get", but the data size is always 64 bytes.
Is...
Greetings,
We are using nrf-sdk v1.3.0.
We would like to monitor an adc channel using either limit event monitoring or maybe LPCOMP.
I was able to find "low level" documentation...
i am using ble_app_gatts example as beacon observer ,till 10 sec after powering up device i need connectable advertise after that period ,as i switch the advertising from...
Can you do successive updates to a Notify Characteristic using sd_ble_gatts_hvs() during the same connection interval without losing data.
The question comes down to, does...
Hi! I've successfully set op an OpenThread MQTT broker using a Rasperry Pi and nrf52 dongle and I am able to publish and subscribe to and from my computer by flashing the...
Hello!
I am working on sdk v17 and ble_app_uart. I'm going to make a button function first in this project. I created 3 functions of 'push, release, and long press' using...
I am not sure whether this is an issue with the nRF53 Engineering Example or with the SEGGER software.
I don't see any errata describing the behaviour I am experiencing...
Hello,
Is there an option to add to thread ncp example a FEM support?? I do according to de guide on the page https://infocenter.nordicsemi.com/index.jsp?topic=%2Fsdk_tz_v4...
