Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hello,
I am trying to execute the SPI slave example from sdk15.2 on my NRF52832 Dev board (PCA10040 1.2.1).
I am using stm32f0 dev board as the master and transmitting...
Let suppose using the dynamic multiprotocol ZigBee + Softdevice application with OTA upgrade possibility. I would like to use the app_timer (along with app_scheduler) to trigger...
I want to change MIN_CONN_INTERVAL and MAX_CONN_INTERVAL values when I connected to phone.
I build function that handler events and send the update to ble_conn_params_change_conn_params...
Hi Nordic DevZone,
I am trying to include the UART driver module (.c .h file pairs) into my new project in SEGGER Embedded Studio.
I have done the following:
I...
Hi,
I have a few issues with flashing the dongle. I am using [ \nRF5_SDK_12.3.0_d7731ad\examples\peripheral\blinky\pca10031\s130\arm5_no_packs ]
When flashing the soft...
I am trying to accomplish the following:
Read values from a number of sensors
Put the device in sleep mode (while keeping the samples from sensors in memory so that...
I found a project named "nRF51-ble-app-uart-static-passkey" on Github,
but I want to set a static passkey on nRF52832(PCA10040).
How can I do that?
Thanks!
Dear Nordic team
It seems there is a small mistage in the mechanical specification of the AQFN package in the nrf52840 datasheet v1.1 p582
The e2 dimension seems wrong...
Hi all;
I want to know how to get setting file data in application layer , which means I want to know the value in address 0x3FC00. From the web , it is easy in bootloader...
Hi,
We are using a custom circuit with nRF51822 chip and Taiyo Yuden BLE module. Currently we are encountering an issue that we cannot detect our PCB over BLE. We used to...
I want to know the version of Bluetooth to connect with. Is it possible to execute the following in an application? Is it possible to reference values in the application?...
