Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hello,
After decided and tried porting nrf_esb from the example code to my project, now I am stuck with changing the content of the payload.
I changed the payload using...
hi, nordic engineers Now I am using the meshSDKv3.1.0 ,nrf52832 . When i test the mesh serial module , it seems not so good, is it a problem? reference to the documents ,...
Hi there
I am currently trying to retain the RAM that is being used by the Softdevice. More precisely the attribute table so that its content does not need to be set after...
i am trying to connect multi peripherals to single "central" and i am using nrf52832 as central, I am using multi link central example for multiple connections but i am not...
Hi!
I am in the process of creating firmware for a product based in nRF52 because the firmware that comes with it does not fit my needs. So I am in the begining of the process...
Hi, I'm new with the Nordic, looks fin but I can't find application command interface description for the PC_BLE_Driver.
Background: I have a running application supporting...
SDK 12.3
nrf51 DK
ARMGCC
Windows 10
I'm trying to switch to gcc. I use 4.9 2015q3 version as recommended.
I have a trouble with simple blank blinky project (nRF5_SDK_12...
Hi,
I update the nRF Connect SDK to the latest version.
I switch SW5 to NRF91 and then erase the flash in nrf91 by using command nrfjprog –eraseall.
Then I use SES...
Hello All,
I am working on nRF51822. I am use IAR and nRF51 SDK 12.3.0.
I want to simultaneously read the value from 2 analog pins. For this, do I create just one adc_init...
Hello, I'm practicing this blog; Segger Embedded Studio - A Cross Platform IDE
on the following environment.
64-bit Windows 10 desktop
SEGGER J-Link 6...
Hi,
Recently we upgraded from NRF52832 to NRF52840, and as the Development seems to come to an end, one of the last features we need is OTA capability.
currently I am...
Using SDK 15.3.0 and S140 v6.1.1, would it be feasible at all to synchronize two nRF52840 modules, each only radiating in an oposite direction, in such a way they would alternate...
Hello
I am using Android and BLE communication with nRF52832 (BLENano2) now.
I am using SDK 15.0.0 with keil uversion.
Central is Android and peripheral is nRF52832...
