Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi,
I recently started experimenting with nRF52840 eval-kits and a nRF52840 dongle using the generic onoff client and server. I used my phone and the nRF Mesh App to offload...
I learning NRF52832 beacon using SDK15.2 i tested code ble_app_beacon code in non connectable beacon mode its working fine. how can i change this code like connectable beacon...
Hey, I would like to add BLE mesh functionality to my existing project which is based on the firmware v2.2.0 https://github.com/NordicSemiconductor/Nordic-Thingy52-FW . I...
I'm planning to connect The nRF52840 MCU GPIO in series to a 1.8V 20mA LED and a Resistor then to ground.
Would the current from the MCU be sufficient to power the LED ...
Hi,
Here is my issue, I don't enter in bootloader by using the buttonless DFU characteristic. Here below I expose my action and what it happens. Thank you in advance for...
Hi everybody,
This is my set-up : nRF5_SDK_13.0.0_04a0bfd, Eclipse 2019 03 IDE, NRF52832_xxAA, s132_nrf52_4.0.2_softdevice, windows 64 bits, NRFConnect 4.22.3, JLINK RTT...
Hello,
we have to integrate the nrf9160 into our own company internal build system / eco-system (freeRTOS based), e.g. not using the complete nordic sdk. As a starting point...
hello,
Now i want to adv only with 37 channel, i want to use SDK15.0.
i add m_adv_params.channel_mask[x] in advertising_init() as:
static void advertising_init(void...
Dear Sir:
I have met a strange problem when using ble_uart example code on SDK 10
1. SDK Version is SDK 10
2. Chipset is Nrf51802
3. the board with no external 32...
Hello Nordic Team, We are using nRF52840 ble chip with S140 nordic stack and SDK 15.2.0 on the SEGGER IDE installed on the Windows OS. We want nRF52840 chip to detect surrounding...
Hi,
I'm working on a project where I need to use an RNG.
I worked with the nrf_drv_rng function with previous SDK but in the latest SDK (15.3) the is nrfx and nrf drivers...
I've been chasing my tail trying to figure this out, and thought I'd have better luck making a post instead. I could REALLY use your help! If you can merely point me in the...
Hi, Considering the new Bluetooth spec. 5.1 and in particular the direction finding feature in the AoA architecture I am wondering if both the devices: the LE transmitter...
