Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
hi,i have a question.
nRF52832,can not Pairing and binding.SDK13.0.0,base onble_app_hids_keyboard example.
It can be paired and bounded before. but now can't pair and...
Hello,
SDK 15.2.0
SoftDevice 6.1.0
DFU with Uart (based on {SDK}\examples\dfu\secure_bootloader\pca10040_uart. Single bank mode as my app is quite big (probably not...
Hi,
I am using Segger Embedded Studio and SDK version 15.2 for NRF52840 based module. NRF_LOG_INFO() works from main.c but not from custom drivers for sensors. Is there...
I have two of the nrf52840 boards and want one to implement a cascade reconciliation between them. That is device A and B have similar secret keys but need to make them match...
Dear nordic,
I tested simple coap thread examples. it's work fine. I want to know some details regarding this.
1. Is it possible to find IP address of all node in one...
Hi.
I am using NRF51822 and SDK is 12.3.0. I know that NRF51822 has random delay(0ms~10ms).
However, there must be no delay to complete the development of the board...
Hello!
I am a master student at NTNU Trondheim working on modelling the energy consumption of NB-IoT for IoT application simulations in cooperation with the NTNU IME IoT...
Hi Team,
I am new to nrf and using Nrf52832 and SDK 14.2.0 for development I am facing a problem, I want to select only Port0 pins as GPIO pins. how to make it. I gone through...
I use the following settings to communicate with the nRF24L. But there is no connection. What's wrong? NRF_RADIO->TXPOWER = (RADIO_TXPOWER_TXPOWER_0dBm << RADIO_TXPOWER_TXPOWER_Pos...
Hi, i'm starting to develop on the nrf52840DK and trying to understand the Nordic SDK (using the lastest version at the time 15.3). Just edited the blinky example to read...
Hi,
I am developing a product using nRF2840 which performs periodic sensor readings.
Due to the nature of the sensor I'm reading from ( sensitive to noises and placement...
Does the current example code for CTS work with an iPhone, by this I mean that the CTS example code is able to retrieve the current time from an iPhone? I have an iPhone X...
