Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
A temperature and humidity acquisition device uses NRF52832, watchdog, RTC timer, external touch button interruption, BLE open state, feeding the dog every minute through...
Hi,
I am having 2 nRF52 DK boards and I have to blink the leds of one nRF board with the help of another nRF 52 DK buttons and vice versa .
How to do it?
Hello,
we recently migrated from SDK12.2 to SDK14.2 and noticed a strange behaviour.
After connecting to a bonded device the nrfx_gpiote_irq_handler is no longer called...
Hello,
with SDK15 the definition of the nrf_dfu_flash_callback_t changed from
to
we used the nrf_fstorage_evt_t->result to determine the success of the operation...
Hi,
My application requires a Bluetooth range from 90-100meter. Can you guide me if you have any BLE chipset validated with an RF amplifier using a trace antenna? Can I...
Hi,
we configure a GATT Server with a characteristic that is configuered for write with authorization. If we then try to write one byte to this characteristic from the client...
Hello NORDIC and Tech support members. I am new to NORDIAC devlopment please support me how I start with nordiac please guide step by step and please let me know how I Start...
Hi all,
Where can I find the default program that comes with nRF9160 DK in box?
I'd erased memory and programmed with AT command program but I would want to program as...
Nrf51822QFAAC0 uses softdevic: s110_nrf51822_6.0.0-5.beta, sdk: nrf51_sdk_v5_1_0_36092. Use serial routines. When I annotate the initialization of serial port, and annotate...
Hi,
I have successfully implement the code demonstrated in the two tutorials shown here:
https://devzone.nordicsemi.com/tutorials/b/bluetooth-low-energy/posts/ble-characteristics...
Hi Everyone
As the subject mention，
RTT stops working when power is disturbed by motor.
But other fuction that like ble,spi,uart are work well ，
I must cutoff...
Hi,
I am using NRF52832 with SDK 15.2. In the example, UART/Serial Port Emulation over BLE. The documentation says that this example uses hardware flow control. Therefore...
