Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hello,
I am having a problem nearly identical to this link Using soft device on custom board with nRF52840 - Nordic Q&A - Nordic DevZone - Nordic DevZone (nordicsemi.com...
Hello,
I am running a single ( main() starts sysworkq thread) thread application in Segger Embedded Studio v5.34a, built for the nRF52833 SoC.
Although I am using a proprietary...
Hi
We are seeing a strange issue when trying to use the Android BLE Library to Android BLE Library to reconnect to two devices. The phone succeeds in connecting to one device...
Hello,
I am going to run DFU over the mesh.
I am using an nrf52840DK and two nrf52840 dongles. I want to send a DFU file through the serial port to the DK and then through...
Hello,
during production test we wrote in the UICR a signature saying that the test has been performed succesfully.
It happens that the signature is not written correclty...
Hi, I'm really pleased with myself as I have set up my VS Code in windows to build and clean blinky and can drag the _build hex file to nRFConnect and flash it to my dongle...
Dear Nordic,
When testing the DFU process, I noticed something unexpected. We are using the secure DFU USB bootloader, with forced dual bank updating. I'll attach both the...
I am using ibeacon format for my device. The specification says to include the RSSI value calibrated at 1 meter in the payload.
Can you please tell me how to find out...
Hi,
We managed to integrate both normal BLE and mesh stack onto our working prototype, powered by nRF52840. So far, it is working well. We are trying to further maximise...
I am using the NRF52840 controller to connect BMD101(ECG sensor) uart based having a baud rate of 57600.
Note: Using UART peripheral example on SDK17
I am trying to parse...
Hi
I've problem on my design when I use voltage translator to communicate with sensors. Can you guys see pictures below:
1.nRF52840 using 3.3v:
1.nRF52840 using...
Hi all.
I want to send my packets in the negotiated time interval.
I sat the NRF_SDH_BLE_GAP_EVENT_LENGTH to 6.
The negotiated TI is 36 ms.
the results are
1- the...
Hello to all,
(If "TLDR" go to "### TLDR ###" in the bottom of the page, where you'll find the straight questions without all the context... ) Me and my team are using the...
