Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi，Dear all:
I got trouble when I change “libuarte example”(nrf52840 DK, SDK17.0.2)，the default example use RTC instance :
NRF_LIBUARTE_ASYNC_DEFINE(libuarte, 0, 0, 0...
Hello Nordic Team, Over the course of development I have had to reverse engineer and pick apart various sources (DevZone, Google, Zephyr documentation, etc) in order to figure...
Hello Nordic
I am using nrf52840, SDK 16.0,
I wish to implement Ble peripheral that advertise a connection request (if no response from central after x seconds then...
Hi, I am integrating BG95 with Nrf52 and have been able to achieve the a basic serial communication, but for a stable application code to handle all the AT commands, I need...
Hello,
I have been recently working on a project that involves transferring potentiometer data from an MCU to the NRF52832 and receiving it over Bluetooth. (MCU-->NRF52...
Hi,
I have using nrf52832. I have done the device sleep by using RTC. But, it's not wake up from sleep. How Can I wake up the device from sleep?
I need help regarding...
I'm facing a rather strange problem with an nRF52832 board I'm developing for. I'm using SDK 15.2 and S132 v6.0.0.
Sometimes, during the connection/negotiation phase, my...
Hi,
Is switching from softdevice S210 to S310 as simple as changing the IRom start address and putting the uploading the softdevice onto the device?
Now I have IROM1 start...
Hi everyone,
I'm using ble_app_interactive (SDK17.0.2) as a starting point for my application, which consists in sending commands from my PC to my nRF52DK, which is in charge...
Hi Dev team,
I am working on a Thingy91 device, and I am sending data out through MQTT.
I need a functionality to send some commands to do assigned tasks from the MQTT...
Hello everyone,
I am simply looking for some clarification on how to correctly handle button presses on the nrf52840 DK, as there seems to be multiple ways to go about it...
Hi,
I'm trying to build a working example of an aplication that uses the ANT+ softdevice (either s210 or s212). I already found out that the PCA10028 and PCA10031 (my board...
Hello,
This is more of a C question and I am new to Embedded C programming, I have this question.
I want to know how to access the flash memory without fds or fstorage...
