Using S120 V 8.0.0.3 alpha, processing a BLE_GATTC_EVT_READ_RSP,
received 0x16 bytes of data but there is more to read. Next call to
sd_ble_gattc_read using the same connection...
Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hello,
I have a question regarding the Secure Connection (SC) OOB pairing procedure of the softdevice 132. As I'm currently trying to implement a secure pairing (Eavesdropping...
Hello,
I want to add the Thingy 91 to the nRF Connect Cloud. The SIM was activated correctly. I've inserted the SIM card and know I'm waiting for the LEDs to blink yellow...
Hi, I am using the UART over BLE example + a timer interrupt + a pwm signal. And I am facing the following problem (error launched by my phone app: ) This happens sometimes...
Hi ,
In order to capture and get the data from the external BLE beacons,
I am trying to simulate this using nrf connect Advertiser option instead of using Beacons...
Hello, i have been unable to read data from my sensor.
uint8_t SPI_ReadByte(uint8_t RegAddress) { ret_code_t retCode = NRF_SUCCESS; //start reading sequence m_tx_buf[0...
The modem reports that it supports states 0, 1, 4, 20, 21, 30, 31, 44 when I give the "AT+CFUN=?" command.
Using the at_client sample, or other software like asset_tracker...
Hi, I am using nRF52 DK with s112 and SDK V15.2.0. I have written an application based off of the uart example, and expanded it rather substantially to use the SAADC and read...
Hi,
I'm trying to create my switch_event by using Event Manager.
And I got this issue: "undefined reference to `__event_type_switch_event' " when submitting my event:...
Windows 10, Segger V4.52c, S132, SDK 15.2.0, nRF52832
I've been through a few posts talking about needing more RAM allocated to the SoftDevice when other services are added...
Is it possible to generate a DFU package for both bootloader-only and fully-programmed (bootloader, softdevice, and app) chips? I'm unable to do so for an nrf52833 using nrfutil...
Converting old code for a nRF51822 to the new SDK(15.3.0) for an nRF52832, this error happens:
#error "Compiler generates FPU instructions for a device without an FPU (check...
Hi all,
After wasting so much time trying to set up simple peripheral device whitelisting single central device, I realised that API has been updated and those old examples...
