Using S120 V 8.0.0.3 alpha, processing a BLE_GATTC_EVT_READ_RSP,
received 0x16 bytes of data but there is more to read. Next call to
sd_ble_gattc_read using the same connection...
Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Dear sir,
If I dump the hex file of this path "nRF5_SDK_16.0.0_98a08e2\examples\ble_peripheral\ble_app_uart\hex" then the code is working fine. But if I dump the hex file...
Part 0 of the Tutorial directs the user to use the Getting Started Assistant, but it appears to have been deprecated.
So I've used Toolchain Manager instead.
Part 1...
Hi,
looking for some examples I found this ticket but links inside seem not working. https://devzone.nordicsemi.com/f/nordic-q-a/146/example-software-for-usb-communication...
Is exist any way to detect IDLE RX line on UART?
I try to use RXTO but this is seted each time when 1 byte comes.
everytime, it changed size of data which will be readed...
Dear Team, I'm preparing an application for nRF52840 that will require to send and receive data collected from two different sources, I2S and UART, two UART or SPI and UART...
Hi Nordic,
Please provide the way to debug not able to write 14 Bytes data into Queued Writes module, my application not get any nrf_ble_qwr_on_ble_evt.
[Project Informaiton...
I am a little bit confused on the steps I need to follow to program the settings and the bootloader files. According to Secure DFU over Serial example instructions ( https...
Hello,
I am trying to download the program to my target using J-LInk. Unfortunately, I get this message (see bellow) and I don't know how to proceed.
Any help is appreciated...
Hi,
I am working on a project that utilizes mesh technology. I'm currently using nrf52832 with NRF Mesh 4.0
There are multiple devices that can act as a server and a...
Hi Folks,
Need some advice. We are sourcing voltage to a variable resistor from an output pin. We've configured this as a high ouput. The overall resistance of the POT...
Hi,
I'm testing ads1292 sensor with nrf52832.
I got some problem when i use spi manager library.
I'm using ble_app_hrs project.
If i use spi manager without advertising...
Hi,
We build a new board based on nRF52833 wlcsp,
I tried to run a simple code with BLE peripheral (ble_app_uart example), and I noticed that the HFCLK is not working...
