Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hello-
Recently, we optimized our BLE4 transfer settings. With the same device, firmware, and payload, we get better transfer rates on iPhone5,6,7 than iPhone 8/X. On all...
Hi
I'm using the mqtt_simple but I altered the code and added some buttons. Like, change subscriber or topic if I press button 1 or button 2 , things like that. What I want...
Hi,
I would like to set up a wireless communication channel between two NRF52840 DK boards. I checked the Nordic SDK v16.0 and found some examples such as \examples\iot...
Dear All ,
After finaly getting all the other stuff in place I tried to compile the examples in the nrf_crypto files.. All of them are giving error bellow:-
Output...
Hi,
I had some troubles getting a custom HID device to work that has both input and output reports to Windows 10 host. Here is my working example template that might save...
I successfully created a custom model (by modifying the generic on-off model) and implemented it into light_switch client and server examples. The goal was to send and receive...
Hello,
I have implemented functionality that enables me to send messages back and forth between two nodes in the network with a timer (both nodes has a server and client...
Hi I have been using the https://infocenter.nordicsemi.com/pdf/nRF_Sniffer_UG_v2.2.pdf I wish to program my nrf52832 device with a hex. Using the j-link commander tool. i...
Hi - I built and flashed the ble_app_interactive example from both SDK 15.3 and then from 16.0 on to my nrf52840 DK (PCA10056). I connect to a Thingy52, issue the gatt services...
Tried with PCA10036 and PCA10031 on Windows 10. Both show as JLink CDC UART Port (COMx) in Device manager. Tried different versions of WireShark. Tried to erase and copy new...
Hi,
Using SDK 15.3.0 , example "ble_app_hrs_freertos", pca10040 with armgcc.
I want to increase MTU and GAP data length.
I started with MTU to 247, and when I try to...
I'm using SDK 16.0.0.
I wish to use two MEMS microphones to record audio over the I2S interface, and then send it over Bluetooth.
What is the best library to use for this...
