Is there a way to recieve more than one write callback for a given characteristic, per radio session? It seems like I can rx 1 time per attribute per radio session and tx...
If it can work with iOS blue setting will be better
I need some reference to dev hid device in IOS
but I can just find my device ,connect ok but not work.
I need to create timeout below 1ms. I would pretty much like to use timer for that because I do not want to hold the cpu inside cycle. For me it is not important the exactness...
Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
nRF52840, nRF Connect
I was looking at the button example and it is apparently a little different then in the nRF5 SDK kit. In the SDK you had a callback and inside that...
Hi!
For a custom project, I need to enable and disable soft device on a peripheral. I'm able to enable/disable softdevice for two cycles, then I get this error:
<error...
Hi,
I'm trying to mount two spi flash device on spi0, but can't found the second one(device_get_binding() return NULL).
The two device has compatible ("jedec,spi-nor"...
Hello Support,
In my project I use the nrf52840 with the nRF Connect SDK to create a OpenThread device with an Secure MQTT connection to a broker.
I've got the OpenThread...
Hi. I am trying to output a square wave on to separate output pins. I want to have one inverted, however I can't even get the same output on both pins at the moment. The pin...
I want to use HCI_USB on nRF52840 board(nrf connect SDK).
Legacy Advertising Scan is success.
But,, I don't know how to recieve the Extended Advertising Scan.
Please...
We have an nRF52840 operating as BLE peripheral that ix using sd_ble_gatts_hvx() to notify an attribute value. Because we are using an RTOS, after calling sd_ble_gatts_hvx...
Good morning,
DK: nrf5340 Audio DK
SDK : V2.0.0
Toolchain Manager: V1.1.3
nRF Connect for Desktop: v3.11.1
I am trying to work with nrf5340 Audio DK. I was able...
Hi,
I was working with my Thingy:91 all worked fine. Wanted to upgrade to latest firmware and somehow in this process the USB interface stopped working. I switched to use...
hi,
i am using sdk_17.0.2 and nrf52840.
I want to get 6 pwm outputs like in the picture.
They all have to start at the same time.
20 khz signals should be.
i...
I want to make sure I understand something fundamental. The nRF52840's PWM peripheral is hardware based unlike the app_pwm library which is software based, (originally developed...
