Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hi
We are developing the use of ESB together with BLE, using the Timeslot API.
We have been using the known tutorial for the ESB timeslot implementation:
https://devzone...
Hi,
We are using nRF52832(lairdBL652) module for indoor application for the prototype version.
We are using nrf52832 for both central and Beacon device.
We have made...
Hi,
I have combined the light switch and the dimming example. The thingy 52 contains one generic onoff server and two generic level server for brightness and colour.
The...
I updated Thingy91 with modem firmware (mfwnrf9160100.zip) and application firmware (thingy91_ltem_v0.2.2.hex) from latest firmware package (thingy91fwv022.zip).
Question...
Hi,
I have nRF9160 DK. I downloaded nRFConnect SDK with source code.
I know that samples compiled with libraries are loaded and executed under MCU on the DK board. Since...
I only want to dfu for bootloader ,but i have some problem ( insufficient resource、 dfu success but my device is crash ).
maybe my bootloader.zip flie is error.
can you...
Hi guys,
I am using mesh server example with UART fuctions integrated into it.
I wanted to send a string through UART.
I tried using app_uart_put() function and this...
Hello,
I was wondering when a device needs to be certified and if that is a country by country basis? If you were to follow the circuit guide lines, would you still need...
Hi, I am using https://github.com/NordicSemiconductor/pc-nrfutil code from here for nrfutil. I am working on both mesh and standard ble application.h I am facing problem keeping...
Hello,
does the nRF52840-DK Board have a I2S interface because the nRF52840 SoC have it but I didn't find it in the nRF52840-DK manual?
I find in the nRF52840 manual ...
Hi,
I'm referring to Generic on/off example and I would like to adjust scan interval and window time.
When I measure power with base code I see that device is in listening...
Hi,
I have seen that it is recommended to let the SIM_DET pin floating when using an eSIM in order to avoid leakage.
What is the internal configuration of the SIM_DET...
Hi,
I'm using a Segger Embedded Studio Free Commercial Use License to develop for the nrf52 family. I'm being notified that I need to renew my license if I want to access...
I am new to the mesh network technology. I am experimenting with the iOS BLE Mesh app provided by Nordic on App store and nRF52 development kit. The App functions very good...
