Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Dear Nordic-Support,
I have implemented some functionality with user defined models on the Mesh2.0.0-SDK. I had implemented both sides (server-client) and i,plemented the...
Hi,
I'm using Uart exemple to post data over BLE.
Everything works fine as long as I'm connecting with my phone with BLE apps.
I would like to connect using a linux...
Hi all,
I'm working with TWI Sensor example. I've followed this https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter.sdk5.v15.0.0%2Ftwi_sensor_example...
Hello,
I want to use ble_app_uart example. I'm usign nRF52832 with nRF5_SDK v15. I need to put the MCU in sleep mode. I can do that. When the MCU awakes from sleep,...
Hi,
NRF52 DK has an RF switch which can be used for looking into the Nordic and observe the impedance using a VNA. I observed the same impedance in RX, TX and power off...
Hello,
i am finding that after i call app_timer_cnt_get() there is a constant power drain.
I have an Ultrasonic sensor. the ECHO pin will fire 2 times into a GPIOTE...
hi.........
how to add the timer mode in hts program , i want to set the timer in my program to receive the data according to timing .
i am using segger 15.2 version ...
When I power the 52840 from a LiPo connected to VDDH and using VDD/VEXT to power 3V3 components, when the chip is put to sleep is the output on VEXT switched off? Or do I...
Hello, above is the PWM modulation waveform (positive Xuan Bo).
How does 1.nrf52832 regulate the frequency of circulation?
Take this nRF5_SDK_12.2.0_f012efa\examples\peripheral...
Hello, I want to use nrf52832 to output waveforms as shown above.
Using the Demo1 example in D: Lianxi nordic nRF5_SDK_12.2.0_f012efa examples peripheral pwm_driver, we...
