Has anyone converted the app note AN34 DTM Python script to C# or C/C++ ?
The Python DTM script is works OK with the setup specified in the app note AN34 figure 2, which...
Hi,
I have a serious problem, when I use uart of NRF51822 QFAAC0 to receive data from another MCU, I found that it will lost one bit at same position everytime. my SDK is...
Hi,
I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...
Hi,
We are using the nRF905 device in an application where it needs to switch between auto-retransmitting and sending single packets, due to it communicating with several...
This is not a real question for support. It's more a success story i'd like to share with you!
Our company develops firmware for various customers on a lot of different...
Hi all,
What is the maximum data rate for the nRF24AP2 when using the Synchronous serial interface?
I cann't see it in the datasheet.
Is there anyone can answer me...
Hi Team,
We have used the "CC310" and "mbed TLS" both the crypto engines in my application with conditional compilation on NRF52840 soc.
We have measured the timings...
Hi,
We are using nRF52832 chip along with soft device and nordic SDK. However we have our own custom boot loader and that doesn't have soft device.
We want to implement...
hello,
I am using SDK 16.0 and I use flash storage to store some value which is critical for our application, when I use fstorage_write as below inside main(),
int main...
I am trying to use the fstorage library to store some data for my application and use the flash_fstorage example in SDK16 as a starting point and copied the required codes...
Hi
i am getting Fatal error while uploading code in my nRF52823 plz find attachment which i enclosed.
and showing break point at NRF_BREAKPOINT_COND; plz tell me what...
Hi Team,
We are working on NRF52840 module with BLE functionalities.Tested the RNG functionalities alone with example project (examples\peripherals\rng ) it is working fine...
Hi!
I'm trying to transfer data from UART to BLE in NRF52810. NRF52810 connects MSP430 controller via UART, MSP430 sends packet of 16 bytes lenght every 2ms (500 times in...
Hello,
This morning I was able to program my kit, but I don't not why I can't do it now.
I'm trying to do it with all the options I know (SEGGER, nrfjprog, program nordic...
hello everyone,
I want to implement the FOC algorithm to control the brushless motor with the nrf52 card. is there a library or SDK that I can use. regards,
Hello all,
I've been working on creating a test app for a product that I've been developing for sometime. It has multiple BLE services such as Device information (DIS),...
HI ,
On my costume board works fine when VDD connected to ~3.6v.
it starts to behave differently when voltage is ~4.1v. (Flashing fails / SW not loading ).
my VDD_GPIO...
Good morning, I am a university student and I would like to know if there is a tutorial or an example to do a simple test of the operation of the new feature of Bluetooth...
I am trying to read ADC values for 8 different channel, in order. It's just to test if the ADC and its API.
I successfully receive the ADC binding (it returns 0), and the...
Affects version: SDK 15.2.0
Building the ble_app_hrs_freertos example produces several warnings in SES. The warnings are related to redefinition of several MACROs.
