Has anyone converted the app note AN34 DTM Python script to C# or C/C++ ?
The Python DTM script is works OK with the setup specified in the app note AN34 figure 2, which...
Hi,
I have a serious problem, when I use uart of NRF51822 QFAAC0 to receive data from another MCU, I found that it will lost one bit at same position everytime. my SDK is...
Hi,
I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...
Hi,
We are using the nRF905 device in an application where it needs to switch between auto-retransmitting and sending single packets, due to it communicating with several...
This is not a real question for support. It's more a success story i'd like to share with you!
Our company develops firmware for various customers on a lot of different...
Hi all,
What is the maximum data rate for the nRF24AP2 when using the Synchronous serial interface?
I cann't see it in the datasheet.
Is there anyone can answer me...
Hello there,
I've been trying to run some basic code on nRF5340 PDK. I downloaded and installed the following:
nRF Connect application v3.6.1
nRF Connect SDK v1.3...
Hi, I have developed custom board on nRF52840 based on Thread and Zigbee SDK 14.1.0.
I wants to use zb_zcl_ias_zone_set_status function to send a report of the changed zone...
I have a problem when using JLinkExe + JLinkRTTClient . My operating system is Ubuntu 18.04, and I compile the project using cmake and gcc (using great helper scripts from...
Hi all,
We have a custom board based on nRF52840, and we are using the nrf52840 DK to program our board(For programming the chip, connection from DK to our board is made...
Hi.
Device : nRF52820
SDK 17.0.2 ( Softdevice 7.2.0)
I initialized the clock as below to use USB.
And before changing to sleep mode, the clock was stopped to...
Hi，
So I was using nRF52810 with epoxy or resin coated，but actually the signal quality did not match my needs, the signal faded about 20dB compared to the device which not...
Dear Members,
I manage to display data from GSC10 sensor ? but after few minutes in idle, it can not receive a data anymore,
How can I restart again ?
Is it related...
I am using the nrf52-ble-app-uart-c-multilink-master getting data from 4 UART peripherals that are connected. Once one of the clients disconnects, I am getting an error as...
I have a custom board using nRF52840. Some boards return success from sd_ble_gap_adv_start but no advertisement is seen in nRF Connect running on a Google Pixel 4 phone. Of...
Hello,
I need help with my application.
I am developing an application running on the EV board nrf9160dk_nrf9160 .I read the following article:
http://194.19.86.155...
Hi,
I am developing an application that needs to communicate with nrf51 module over BLE. Specifically I need to write a string on a given characteristic but unable to do...
Hi all,
I was going through the nRF Connect SDK tutorial and was trying to get the "Hello World" example running on a nRF5340-PDK (PCA10095, 0.8.0).
Before that I was...
