Hi ,
I would like to know if a matching network is needed if I am only using a single external flex antenna for both LTE and GPS using a RF switch between them and a uFL...
I am a student interested in Nordic.
My coding skills are very poor.
So I want to get help.
I want to use the vl53l1x sensor in nrf52. (My ultimate goal is to measure...
I have a working project where pin 16 is configured as a low-level interrupt source.
it is working well with SDK 15.3
after porting to SDK 17.0.2, it is not triggering...
Hello Nordic Support Engineers and fellow developers ...
Just a note to thank everyone for help via this forum. I started very inexperienced with Nordic SDK a year ago and...
Hi,
I recently purchased a thingy91 for a project. I'm trying to follow instructions from a Nordic youtube video ( https://www.youtube.com/watch?reload=9&v=xQ7hDzRULJQ ...
Hi,
I want to use the MCUboot for the DFU and I have been able to configure it and flash it on the device so far (tested that it is correctly flashed).
But I need to make...
Greetings,
I want to write the nRF Connect SDK v2.0.0 sample "nrf9160/https_client" to the nRF9160-DK, but when I use "Flash" in Visual Studio Code, the following error...
Hi,
I'm designing a drone based on these three Nordic IC:
nPM1100
nRF5340
nRF21540
Let's Start with nPM1100:
Based on this Reference circuitry
I based my...
On SDK 2.0.2, I was able to load peripheral_uart with CONFIG_BOOTLOADER_MCUBOOT=y and successfully update both the app core and net core using the thingy53. However when moving...
Hey,
I bought a device which uses the N52832 SoC, Im gonna attach a photo of the device. Is it possible to get the code from the device, modify it and then upload it to...
Do you know of any way of reading the installed modem version of an un-locked nrf9160 through the j-link programmer. I would like to conditionally program the modem firmware...
Hello ,
I want to use OLED display having SSD1351 driver with nRF52832 DK board over SPI. Is there any library or support available ? Please help to share if it is available...
Hi,
We have a peripheral based on the nRF52840 which connects to a smartphone as the central.
Following the guidelines for iOS we have selected a connection interval of...
Hello Devs,
I am testing an nRF52840, configured to operate to 1.8V using the DCDC converter. All pins are supposed to operate in a 0-1.8V range.
So my question is...
Using 52840, I would like to drive an external device at 800Khz
Works well without enabling the SoftDevice
But once the SD is enabled - this does not work
Ideas?
I used 9160 to develop a product for the customer. Previously, I used ncs1.2.0 SDK, and the power consumption of the whole machine was about 200uA. Now I am going to use ncs1...
Hi mate,
I followed the link (+) Add DFU support to your application - Software - nRF Connect SDK guides - Nordic DevZone (nordicsemi.com) step by step and its worked...
