I have a working project where pin 16 is configured as a low-level interrupt source.
it is working well with SDK 15.3
after porting to SDK 17.0.2, it is not triggering...
Hello Nordic Support Engineers and fellow developers ...
Just a note to thank everyone for help via this forum. I started very inexperienced with Nordic SDK a year ago and...
Hi,
I recently purchased a thingy91 for a project. I'm trying to follow instructions from a Nordic youtube video ( https://www.youtube.com/watch?reload=9&v=xQ7hDzRULJQ ...
I have a nRF5340PDK, Now I want to know the lowest power consumption of this chip in different condition, such as adv, connect, sleep. But I am not sure how to config the...
Hi, i am using:
-nRF 52 DK
-nRF 52832
-Sensor of Maxim Integrated
-SDK 17.0.2
I have some problems in handling the I2C through the nrfx module.
This is my ReadByte...
Hi, I have a set up consing of an nrf52840, a Raspberry pi and a Linux workstation, which communicate over IPSP following the IPSP sample from Zephyr OS. The nrf52840 is a...
When pairing with nRF Connect and nRF52 I use the Just Work mode. No Keyboard No Display.
In 4.2 (and also 4.0) the MITM cannot be used in this mode.
If I set it on the...
Hi Nordic Team
Am trying to create DFU.Zip packet using nrfutil am getting this error while creating( DFU.Zip packet) for the sake of testing secure bootloader .
Am using...
after installing the new SDK for the nRF9160.
if I install the new spm on a board that is working and it will still run the old code that was present on the board befoe...
Hello dear community,
I had a question related to the Circuit configuration no. 5 within the document "nRF52840 Objective Product Specification v0.5.1". There are two inductors...
Hello!
I have some question regarding At commands and logging information from the modem.
Is there a limit to how often one can issue AT+commands and get responses...
Hi! I want to send data from nrf51 to another nrf51 multilink_central! I don't have any problem about sending data! It's work with a perfect way! But my problem is how to...
Dear All,
I'm Starting the Design of nRf52832.
I need GPIO configuration of nRF52832 with its Alternate functionality like Peripherals UART, SPI, I2C and external Interrupts...
Hi,
I am new to nRF52832 software and Segger Embedded Studio. Was trying to comiple an example code based on ISP4520 which is based on nRF52832 device and am getting following...
Hi,
We are in the process of adding an external GPS antenna to our board and following the guides in the documentation feels a bit risky since names for circuit board...
I tried to redefine weak app_error_fault_handler by custom one (nRF5 SDK for Thread and Zigbee v2.0.0, Segger Embedded Studio), according to https://infocenter.nordicsemi...
