I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hi, I am developing using nrf52832 and st7735s.
Successfully displayed the lcd screen using the code in \examples\peripheral\gfx
However, when screen clear, text_8print...
Hi,
In my application I need radio notification only during connection. When connection is dropped the peripheral goes to advertising mode and here i disable the radio...
Hi all again guys! I am experiencing a problem with my application: i have a beacon that is sending ADC converted values to a nrf51 DK (via notification), which is connected...
Hello,
I want to use SPI between one nRF51-DK (using SD130 v 2 and SDK11) and another board. I am supplying the nRF with 2.3 V and initializing the BLE and the SPI. I can...
I have a BLE application in mind in which it would be useful for the BLE server to obtain the battery level of the BLE client (in this case, a phone, laptop, or tablet). I...
Hi,
Is Nordic looking to support mbed OS on the nrf51/nrf52 series chips?
Currently it looks like the best supported platform is the mbed Classic SDK, but it looks like...
Hi,
I am trying to make a program for the NRF51 development kit on mbed. I have been able to take ADC samples at 1000Hz which is what I want, but I can't seem to print...
In SDK 11 description od DTM "vendor specific" settings, there is a lot of inconsistency in parameters names/numbers - could anyone help me understand this part?
As for...
Hi,
Everyone,
I have firmware working with our custom pcbs.
It works fine with new 3.3v battery.
But somehow it does not advertise anything with used battery having...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
I guess we need some help with definitions. Basically, we'd like to read data from an I2C line. Should be as simple as "set to input" and "read the pin". However...
In...
Using nRF5 SDK v11.0.0, I am working on bringing up new hardware based on the nRF52. I started with code that works on the PCA10040 development board in which we connected...
I need to calculate radio on time in IoT SDK but IoT softdevice don't provide ble_radio_notification (in sdk components) and nvic functions (don't have nrf_nvic.h in softdavice...
