Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hi,
How can I detect environment radio noise in each ESB radio channel?
Would you please give me a sample code which can detect environment radio noise?
Thank you...
I'm reading the SDK15.2 documentation coming from SDK 11. I've noticed the nrf_pwr_mgmt module, but I haven't seen it utilized by any of the examples. When should this module...
I implement basic Thermostat Zigbee device on top of FreeRTOS v10.0.0 with nRF Thread and Zigbee SDK in version v3.0.0 When there is no network to connect then after some...
I am working long nrf52840 and trying to implement long range in my project. There were examples in SDK 15.2.0 but i couldn't find any example or post which is related to...
Hey,
I'm using the nRF52840 dongle with SDK15.3. Am trying to make it a central device that is configured as a HID mouse when plugged. So I'm combining both multilink_central...
Hello everyone,
I got an issue with the custom board nRF52832 ( Raytac BLE module ) as I only achieve very short distance between the BLE device and Android app without...
Hi,Master:
When I use the QSPI library to communicate with flash, everything works fine. After a complete read and write, nrfx_qspi_uninit() is called to reduce power consumption...
Hi i am using nrf52832 development board as central which scans for peripheral devices.
how to get peripheral device service UUID(128 bit) completely before connection?...
Hi there,
About radio packet config, would someone please help?
1. Meaning of the LENGTH filed in packet structure. Is it size of payload or of the whole packet? ...
Hello, In a product already in the hands of the users we started getting some issues when connecting to Android Devices
Using the nRF Connect Android Application whenever...
Hi, I have been working with my nrf51 DK for a while now without problems. When I first connected the board to the computer today, the ld5 led was blinking very quickly, and...
hi
i have a question. I'm working on a type of beacon system and need to advertising repeatedly unique beacon in less than 100 ms advertise interval that limited on non...
Good day!
In Light Switch example I made some changes to have GPIOTE events, instead of Simple HAL.
Now, when I try to publish message, debugger shows error in bearer_event_in_correct_irq_priority...
