Hi to all Nordic product lovers,
This is not a question but rather an announcement of a new nRF52840 based finger tip size module 14 x 9 x 1.6mm launched at CrowdSupply...
Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi,
After successful building of pca10040_s132_ble_debug example with changes to project :
- excluding SEGGER_RTT_Syscalls_SES.c from build
- from flash_placement.xml...
Hi,
We are hoping to send our samples for CE certification. We use nrf52805 IC in our design. We do not use any precertified modules.
Looking at the Direct Test Mode folder...
Hi!
We're working on a development project using nRF52832. Our original prototyping PCBs used the nRF52832-QFAA. On these boards, the nRF worked without issues, and we could...
Hi,
I have builded a circuit with a nRF52DK and a mpu9250 IMU. If I power the Sensor with VDD the Zephyr driver and all of the Software performs well and the values from...
Hi,
I am using nrF52840 with nRF Connect, Visual Code Studio (Zephyr)
Is there any guide or a tutorial with an example that shows how to create a static library on nRF...
Dear Sir,
Good day.
I was able to determine the peripheral devices which I need to connect based on sdk v12.2.0. I can compare the adv name and device name during BLE_GAP_EVP_REPORT...
Hello all!!! I am new to the field of antennas and have lately been struggling in understanding antenna matching networks. All that I know as of now is that antenna matching...
Hello Everyone,
Hope you all are doing great.
I want to enable the Green power sink on the light bulb application (Zigbee). As per Nordic documentation, i have enabled...
NCS 2.1.0 / nRF52840-DK
Hello,
I have a single write characteristic on my service:
BT_GATT_SERVICE_DEFINE ( custom_srv,
BT_GATT_PRIMARY_SERVICE (BT_UUID_CUSTOM_SERVICE...
Hi I am using app timer in my software and in the timer handler i do multiple things which can take up random amount of time. I would like to know the time taken from the...
Board: nRF52833
SoftDevice: s140
SDK version: 17.0.2
I'm trying to port my project from segger to vscode. My project gets compiled fine but when I run it I'm getting...
I stumbled upon this commit where SPI support for the BMI270 has been added. Could you guys help me applying this to a nRF Connect SDK v2.0.0 workspace?
Hi,
How does pairing and connection happens in nRF5340 Audio DK? I have 3 DK.
While building SW, I configure json file with the 3 DK's product code and then flash in all...
