Hi to all Nordic product lovers,
This is not a question but rather an announcement of a new nRF52840 based finger tip size module 14 x 9 x 1.6mm launched at CrowdSupply...
Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
The below source is mine.
ble_app_beacon.zip
I know that it is possible to display the information in the manufacturer data or service data.
I chose which manufacturer...
Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
I'd like to use the GATT/GAP driver from an ARM based Linux system. Is there any possibility of getting a library compiled for ARM or (cough) the source code to build it myself...
I am trying to write my firmware in mbed instead of microvision. I have my own custom PCB w/ the nRF51822 and use SPI with different GPIO pins than the standard ones.
My...
On the following code I have a packet of 6 bytes that I write to a buffer. I pass the buffer as read_packet function argument. When optimized, the code doesn't work. I only...
It is possible to run easily a SoftDevice stack (e.g. S110) on nRF51422 using an accurate 16MHz external clock reference for HFCLK instead of an external 16 MHz crystal oscillator...
hi, nordic staff.
i'm working with s120 v1.0.0. and i recognize that the transmission and receive buffer is only one for every connection(up to 8 simultaneous connection...
First, I flash the softdevice, then I flash the bootloader, then I use a smartphone app to upload an application to the device via BLE.
but, The first operation only. When...
Hello Nordics.
I developed a device that display a navigation information using s110 (nRF51822)
My device receive the road information by an application.
But, when...
Hi,
I'd like to get a timer with 1ms interval or higher resolution, and found some questions about this:
If the app_timer is used, looks like we only can get minimum...
Hello Everyone,
Scenario is i am getting some commands from Master(Android based Mobile App) to start some function , After i get the commands i disconnect from master...
Hello,
I tried firmware over the air update with mbed using the compiled bootloader hex file and it works pretty well.
However, I am back to GCC with softdevice 7.1...
