Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
We are looking for an experienced software developer, for existing board with using nRF Connect SDK. We are using nRF52840-dk.
Please, contact me if you are interested.
My system runs 2 concurrent connections, one as a central and one as a peripheral. I am trying to get better throughput.
Initially, I had a problem where the central role...
Hi,
I had a working application for both central and peripheral devices. I did a code refactor of rf application layer on central side (I didn't touch any connection parameters...
Hi everyone,
I Am using Settings subsystem modules to store persistent value in the flash and the zephyr storage Backends is NVS ( CONFIG_SETTINGS_NVS ).
I Am t rying...
I am building a system that periodically emits a beacon (ADV_NONCONN_IND) at the same time as scanning the central role using S132 v7.2.0.
Regarding the subject, when...
Hi - I am trying to commission my NRF5340DK board with NRF Connect SDK v.2.1.1 using Google Home App over Matter using the Matter light bulb sample.
My OTBR is a Google...
Hello,
When I starts my SLM application with lwm2m carrier library, I receive this right away:
My issue is that I don't want modem to start in active (CFUN=1) mode...
Hello Team,
We are currently experiencing an issue with the PPK II.
Yesterday, we updated the software, including a Bluetooth low energy update in the nrf desktop app...
Hi,
I am trying to develop an MP3 player I want to configure LRCK to 44100 but I only able to configure it to 43530 with configuration available in document as CONFIG.RATIO...
Hi,
Set the module mode to CAT-M1
Please provide the highest frequency B1 B3 B8 B19
Please provide B1 B3 B8 B19 lowest frequency
Please provide B1 B3 B8 B19 center...
Hi everyone:
I developed an application based on freertos, but when I download it, I found it can not start, but when I use the RTT to connect my device, It worked.
The...
I selected "All boards", but the nrf52840dk board is not listed. I have tried uninstalling and reinstalling the nRF Connect extensions in VS Code, but the nrf52840dk board...
I want to use public-addr and non-resolvable-addr for advertising on nrf connect SDK.
I was able to advertise using a random static addr.
But, 1. can not set public addr...
hi I am configuring a BLE peripheral using NCS v2.2.99-dev3 and the nRF5340 DK. I want to set the security level of the device to mode1, level 4 for cyber security. I searched...
Hi team!
I have some doubts regarding updating the advertising data using periodic advertisements. We were able to advertise 1,650 bytes of data using periodic advertisements...
hello Nordic
i am working with nrf52832 with ncs v1.9.2 with zephyr
i am using spim to read from a sensor
the spi xfer command is done via ppi with a timer ~20kHz
...