Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
I have an issue installing manually on a Linux machine using the steps outlined at https://developer.nordicsemi.com/nRF_Connect_SDK/doc/2.2.0/nrf/gs_installing.html The `west...
Hi everyone, I'm currently using a nRF52840 module from EBYTE and I saw that they have a 32MHz external clock on it.
I wonder if there anything I need to config to run Bluetooth...
Hi,
I have a deployment of 150 Mesh nodes, 3 gateways and 3 LPNs at a customer building. See my previous tickets about the issues I faced, but eventually I resolved them...
Hi there, we are currently developing on both the nrf5340 and nrf9160 DK's. Both boards are intended to run at 3.6V using the PPK 2.
Recently however, we ran into an issue...
Hi,
I am using SDK 2.2.0 and using NRF_LOG_DEFAULT_BACKENDS_INIT () throws 'undefined reference to `NRF_LOG_DEFAULT_BACKENDS_INIT''.
I have set CONFIG_LOG =y in prj.conf...
Hi,
A simple question about 5340 hex image needs you to clarify.
I use vscode to create a example(zephyr/samples/bluetooth/peripheral_hr) with 5340 board config. Then...
Hi,
We had a product developed with nRF52810( SDK15.3.0 ). Now we want to test RF frequency offset by signal carrier detection.We want to enter factory test mode to transmit...
hi
I am trying to verify BLE between a PC and a development product using the nRF52840 dongle. After installing pc-ble-driver-py, I checked the basic operation of the dongle...
Hi nordic team, I use the ble function of the nrf52820 chip to transmit small data, and I have some questions. I have the following two sets of connection parameters:
First...
Hello everyone
I am implementing a device network that communicates in modbus rtu (both master and slave).
I would like to be able to update the firmware of my devices...
Hello, I have created settings file and merge sd + bootloader + application with following commands :
nrfutil settings generate --family NRF52 --application app_name.hex...
Good day,
I tried to build a simple sample: "blinky" using west build command for my nRF9160 DK.
However, file generation failed with the following errors: "ModuleNotFoundError...
Hello Everyone,
I search a lot of time but I don't find any solution.
I looking for a solution to send "command" when the nRF52840 have an USB Mass Storage configuration...
We just switched module provider and used P0.03 as an input for the UART Rx. We tried everything and it didn't work, and switching to a standard I/O it didn't register the...