Hi,
I'm trying to find out how people automate current measurements with the PPK2 beyond doing it by hand in the Power Profiler app.
From the threads here it looks like...
During the setup process for nRF Connect SDK v2.4.0, an error occurred preventing the SDK from installing correctly.
The environment details are as follows:
* macOS...
Hi,
We are using the nrfconnect for thread and zigbee 3.2.
We have modelled our Bluetooth peripheral, running on the nrf52840, on the BLE UART example. It connects fine...
I have installed nrf-command-line-tools_10.24.2_amd64 and jLink_Linux_V794e_x86_64 on Ubuntu 22.04. I have also installed nrfconnect-5.0.2-x86_64 for desktop and the Toolchain...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
I want to setup pairs of nRF51-dongle and nRF51-beacon where dongle-1 will always bond with beacon-1, dongle-2 with beacon-2, etc. If dongle-1 and beacon-2 are switched on...
Hello,
I am using the ADC input on the nRF52 DK and its working correctly. Its setup right now to use its Internal Voltage as Reference. I wanted to know if there is anyway...
in nrf52832 ，We know that there is a process of RF signal ramp up between tx en and tx ready signals. Will RF signals be transmitted during tx ramp up preparation time? If...
Hello there,
I tried combining the GNSS simple sample code to my edited version of the MQTT simple sample code and I am unable to build anything. I am getting this error...
Hi
I am currently trying to create ADC and BLE Services using nrf5340 DK for evaluation before jump to custom board. So based on several threads in this forum, I found this...
Hi,
I am developing my application on top of low power node example available nrf sdk for mesh v5.0.0. The idea behind the application is that after the node is provisioned...
Hello there!
The nrf52832 qfaa reference circuit uses a coplanar waveguide for the antenna section, leaving a keep out area on the inner layers beneath the matching network...
Hi,
I wont to disable serial to lower the power consumption on my Icarus board. I am using the AWS IoT example which uses the AT HOST Lib. If I try to disable serial using...
Hi there,
I was using a PCA10040 DK (V0.9.0, 2015.49) to try out nRF Connect SDK samples (peripheral_lbs) and suddenly found I couldn't program, erase or recover the device...
My custom connection-less BLE sensor beacons (nRF52833) will advertise a simple event e.g., opening a door on trigger-only. Up to ten or more such beacons may be sensing at...
Hi,
I was working with ncs2.0.0 and using the CONFIG_AT_HOST_UART_1 =y config command in the .prj file to change at_host uart config from uart0 to uart1 and I was able to...
Hello,
I'm trying to send message to ZC from my ED using Messaging Cluster.
I've added Messaging cluster with no attributes and I can see it on the ZC side.
Next I'm...
