Hi,
I find the CSCS example program reading zero at low cadence levels below around 50 rpm.
Using ble_peripheral example ble_app_cscs loaded into the PCA10040 board or...
I had manged to deploy and configure mesh networks on Nordic Thingy devices based on these 2 examples separately. 1. Generic OnOff models https://github.com/NordicPlayground...
Hello,
I am unable to access my SRJ profile with email id [email protected] due to two factor authentication. i do not get anything in the google authentication app...
The link for downloading nRF6939 live cd v5.4 is broken.
https://www.nordicsemi.com/Software-and-Tools/Reference-Designs/nRFready-Smart-Remote-3-for-nRF52-Series/Downlo...
Using one ADC, the current can be reduced to about 40uA after the ADC value is taken. Using a two-channel ADC, after the ADC value is taken, the current stops at about 0.4...
I'm searching for a software engineer who can help us getting OTA support between nRF52810 and PIC16 MCU.
nRF52810 must have command- and data mode over UART, Pic controler...
Hello,
I cannot use the nRF Sniffer because it is always crashing. This is a confirmed bug in the Software and the OSX client written is working flawlessly.
I have experimented...
Hello,
I am newbie with KEIL/SEGGER, I have been following this tutorial to compile the example experimental_ble_app_blinky_pca10040_s132 for my nrf52 chip, the project...
Hello,
I am using sdk 12.2.2 and nrf51 dev kit. I am trying to upload ble_app_gls example code over the air to nrf51 dev kit. I can find only secure_dfu code in the sdk....
I am considering build some of my own shields to interface with the nRF52DK for the 832 and 840. I am curious how I should use header P5 with the shield detect pin. Should...
Hello,
I am trying to implement my custom service with NUS. I have gone through almost all the solutions presented on this forum.
Observations:
The board does...
Hi,
I need to be able to change the GAP parameters of my connection for only a short period of time to save battery life but have high throughput when I need it. My firmware...
Our workshop is using custom PCBs for other manufacturer's developer kits, and I'd like to do a similar shield for our nRF51-DK boards. Can anyone provide a KiCad project...
Hi all,
I took the example SPI program and I am trying to add UART code to it to debug the SPI transfers. Both examples are working well for me separately. I was able to...
I am working one one star network system with NRF24L01+. I got success with one pair (Single TX and Single RX) on communicating. But I could not get any positive result for...
Hi,
I'm working with an SPI FLASH chip that has a page size 256. I noticed that when I call nrf_drv_spi_transfer() , the rx length of 256 rolls over the uint8_t container...
Why the SPI clk doesn't work, i checked using an oscilloscope :/
I also don't get any SPI interrupt and no data change in the RX buffer although I have wired MISO and MOSI...
Hello,
I just encounter a compatibility issue between the two SDK (11 Vs 12).
So i have so product on the market base on SDK V.11.0.
I m developping an update based...
