Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
Hello all,
I'm trying to connect to custom Board with nRF52840 controler.
nRFgo Studio (V:1.21.2.10) gives error "No device detected, or readback...".
I've also tried...
Hi there!
I have the following setup:
A Raspberry Pi 3 B and a nRF52840 Development Kit acting as a Border Router as described in the official documentation ;
Another...
Hi!
I would like to know if it is possible to use the nRF52840 to read a mifare classic 1k card?
If it is, is there an example for this?
Thanks!
Andreas
I am currently developing a code that will serve as my pulse sensor. I am now trying to write the code in VScode, for it is very appealing to me. The problem now arises with...
Hey
This is sumanth. I have worked on light switch example with server, client and mobile as provisioner. I would like to develop a mesh network where the server has to...
history: https://devzone.nordicsemi.com/f/nordic-q-a/44018/softdevice-invalid-memory-access-info-0x2/172932#172932
compiler: keil
To solve the hardfault issue (SOFTDEVICE...
Hi guys,
is it possible to print in blocking mode by request?
I tried to use a return value from SEGGER_RTT_printf(0, "some text\n"); but the value is always the same...
I have many nRF24LE1E chips that have a corrupted Info Page. I use the Dataman-48Pro2 programmer. I have read and saved the Info Page from a working chip but have not been...
nRF5 SDK for Mesh v3.1.0
SEGGER Embedded Studio
Softdevice S140 v6.1.0, Softdevice S132 v6.1.0
Two nRF52832 DK, One nRF52840 DK
Windows 10 Pro
Hi, is it possible...
Hello,
I have a nRF9160 DK Development kit, and I would like to use it to replace an Arduino uno.
I need to do Analog to Digital Conversion on A0, A1, A2.
I need to...
Hi,
I currently try to build a little thread network with a border router bridging to ethernet. I did everything like in the Border Router Quick Start Guide and as far as...
Hello guys,
I am trying to work on an advertisement model where I have a transmitter(nRF52832 DK) which should advertise specific data only for certain amount of time say...
