Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
hi.
How do i do ble_app beacon advertisement to one device(Android phone) whose bluetooth address is known ?? I want that beacons should only be seen in nrf_connect app of...
Hello NRF ,
I have used NRF52832 with BLE advertise and peripherals connected on two different I2Cs ( temp sensor and gyro sensor ), One SPI( LCD Display ) , three GPIO...
I'm working with nRF52840 dongle, i installed nRF Connect for Desktop on windows but the led didn't start pulsing red. Has anyone else had an issue like this?
I am using SDK 16.0.0. I want to switch from a NON-CONNECTABLE, NON-SCANNABLE advertisement to a CONNECTABLE, SCANNABLE advertisement. I launch the first advertisement and...
Hello, I have a bit of a weird case. I'm sending data over Bluetooth. In the begging, I wrote whole data handling in the main.c main loop. everything worked nicely, so I have...
I'm developing uart program to communicate with arduino with nrf52840. And I'm working on s140 sdk.
First, I tried this code. It works, but first byte that send from arduino...
How can we get the timestamp using RTC(Real Time Clock). Do we need to add the external RTC for nordic thingy 52 board?
I am using the RSSI concept to calculate the distance...
Hello,
I have been trying to debug a curious behavior leading to higher energy consumption (~17mA) on my Sleepy End Device (Rx is off when idle).
I am using the nRF SDK...
I'm using nRF Connect v1.5.0 and Segger Embedded Studio (SES) to develop an application I'm testing on nRF5340-DK.
I want to create a "repeater" that has at least one...
When I use "Go" under debug, I get errors saying "No bootloader was found" and "ERROR 4 [NRF_ERROR_NO_MEM]".
However, when the same exact code is run on my friend's laptop...
Hi Nordic team,
I am having issues to connect to my Nordic device. The connection times out. By doing some research on the dev zone, it seems a known issue that could...
What is the fastest I can update information from the sensor to the nRF Cloud in terms of information every so many seconds?
This in reference to the asset_tracker file...
i have a custom NRF52832 board.
it have a 32mHz crystal but have not 32kHz crystal.
i use keil Uvision for programming, compile and burn the chip.
i use this example...
Hi,
I have been working with nrf5 sdk for my projects and now i am trying to port it into the nrfconnect sdk.
It looks a bit confusing and not able to find the proper...
