I WANT COMMUNICATION BETWEEN A NRF51422 AND NRF528321 BOARDS, IN WHICH IN NRF51422 BOARD I WILL MEASURE PWM COUNT(IT IS PHERIPHERAL) AND SEND IT TO NRF528321 BOARD WHICH IS...
Hi,
I've been working on a way to detect and prevent replay attacks when beacons are used for sensor data. This is mostly used for home automation sensors, where I have BLE...
Hi,
For our current application we have migrated from SDK 13 to SDK 14. We are using RTOS to handle the functionalities of our application. We replaced our own task for handling...
hello,
I use nrf51822 + S130 + SDK12.2 in my product, nrf51822 work at central + peripheral mode，and i use nrf_duf_flash module for my dfu funtion.
The problem is, i...
I want to communicate Central and peripheral devices with KeyPass. Also I want to generate keypass in Peripheral device. But keypass should to include symbols, low/upper case...
I am using SEGGER Studio on MacOSx.
When use the latest mesh SDK, I can run the light_control example and see the debug log in the Debug Terminal of SEGGER Studio.
However...
Hello,
I'm trying to setup a nRF Cloud Bluetooth gateway using my PC (with openSuse 42.2 64bits and rRF Connect v2.1.0 + nRF Cloud Gateway v0.9.7) and a nRF52 DK and I...
Hi,
I found a topic that discuss the LPUART power consumption.
In this discussion, it is mentioned that the power consumption of LPUART was introduce by GPIOTE IN, which...
Hi! I've been trying to get the QSPI peripheral working with my hardware's external flash (up until now I've just been bit-bashing)
I've got two main issues...
First,...
Hi.
I use 5340 + spim 32M (nrfx driver) + ncs 2.0.2 + LVGL library. (display driver ic is RM69090)
I try to communicate display with spim and success work. but refresh...
hi devzone
I tried connecting nrf52832 dk board - debug out to bluetooth module nrf52832.
I refer to this picture.
at fisrt, it was successfully to connect dk...
Hi Nordic,
I have got an nRF52833 DK PCA10100. In SDK17.1.0, there are few examples about nRF52833, for example, what should I do if I want to use examples\ble_central\ble_app_multilink_central...
Hello,
I attached LIS2DS12 accelerometer sensor driver to the nrf5340 board, and I am trying to do (1) i2c access and (2) single tap interrupt handling (the sensor activates...
Are there any samples that show how to use the nRF PPI subsystem with nRF Connect?
My task is to configure the SAADC to take samples at 200hz, collect the samples into BLE...
Hello to the community!
I have two nRF52832 sensor nodes and aim to implement synchronized sampling of all sensors, including synchronization between sensors of the two...
Hello,
I've implemented DFU OTA updates and it works using the nRF Connect app. If I wanted to do this from a custom app from my phone, how would I approach it?
I've...
Hello,
I'm using the nRF Connect SDK v1.9.0 and a nRF5340 on a custom board.
I want to use MCUBoot as a primary bootloader. On the development kit, the UART connecting...
We have updated our firmware runnung on an nRF9160 from SDK 1.9 to SDK 2.1 using the now deprecated SPM (We will upgrade to TFM soon).
When booting our firmware, we initialize...
