I would appreciate some suggestions on a good development flow to go from an Example to end application
I have nrf52832 on a custom PCB.
I tested several sdk13.0.0 examples...
If anyone will ever have this error:
When using c++ and singleton the use of operator new is not possible.
I found the solution in this post: forum.arduino.cc/index.php...
Hi I am using Jlink board, when connected to my pc, I can't select nRF5x programming.
Version I am using is 1.20.0.2. I tried the uninstalling everything and installing....
Hi guys,
In the iot sdk in mqtt.h there are typdefs for "mqtt_topic_t " and "mqtt_subscription_list_t".
I'm trying to set several topics (5) and subscribe to them.
...
Hi,
I am using nrf5832 that is running a coap server example.
I have modified it a little so it reads sensor data via i2c and returns the data using the coap callback.
...
Hi,
I would like to receive some suggestion about finding a CHEAP smartwatch / wristband already available that has these minimal features: BLE (with SDK / GATT profiles...
Compiled with Keil4 software compilation and C of the mixed program, the error is:Branch offset 0x00000228 out of range of 16-bit Thumb branch, but offset encodable in 32...
Hi all
In nRF52840_PS Pin assignments sheet, some pins Recommended usage is " Standard drive, low frequency I/O only ", does that mean only low frequency (up to 10kHz...
Hi,
I am writing an application that reads data from the I2S interface, adds it to a queue and sends it via BLE (the code I have implemented so far is added at the end of...
Hello,
I am using the 802_15_4 MAC api to configure my device as a coordinator.
After it has been configured as a coordinator I want another device to connect to it...
I am using nRF52805(SDK 17.0.1 & S112) in my application development. Designed GATT Table Having some custom services with read, write & notify properties, And also, there...
I am testing advertising mechanism of nRF52832 device. But the following error occurred.
app: sd_power_system_off() failed, errCode=0x2006
The following is log messages...
It appears that an incorrect value is being used as the reset handler address so that the jump from bootloader to application is to the wrong address.
I am porting a bootloader...
I can not program the NRF52840 with the programmer software on windows 8.1. However when I run a virtual machine in oracle virtual box using windows 10 it works. I would rather...
Hi all
I have two units, one acts as Central and the other one acts as Peripheral.
I erase chip of one of the units, and then always failed to pairing, with a BT_SECURITY_ERR_PIN_OR_KEY_MISSING...
Hi,
I'm writing an app that creates a CSR, has it signed by a (web-)server and subsequently uses it to authenticate to another (mqtt-)server. For the CSR generation and...
I am trying to port a project to an NRF52810. The project uses a bootloader with a modified transport to work with a proprietary RF protocol. The bootloader/app works on the...
II have a question on how to automatically activate the change from “minimum BLE advertising interval” to “maximum BLE advertising interval” after (for instance) 30 seconds...
I'm unable to use the PSA crypto methods when OpenThread is enabled on NCS 1.9.1. Linking fails with undefined references to PSA crypto methods.
To reproduce, us the nrf...
hi，
i have just to develop an appilcation with NCS 1.9.1 of nrf52840. Now I have tried to activate DFU and I had to realize that the image size is too large（490k without...
I have a design that had previously only used Serial communication to talk to the NRF52840 and did not use the USB interface. For this coming design we want to use the USB...
