Hello!
I am working with the example mpu interface projects located at the following repo:
github.com/.../nrf5-mpu-examples
After converting the Keil projects to...
I'm using S332 0.9.1 with freertos. nRF52.
BLE and ANT are both active. I would like to run the ANT continuos wave (CW) test after a specific trigger (a command over a console...
I want to encrypt advertisements using aes-ccm peripheral present on the nrf51 board. I am not using softdevice, instead I am generating my own packets and transmitting them...
Currently, it using the I2S at nRF52832.
I want to play the wave file,But can not play well.
So, I ask you for a check because there is the following question.
[Question...
We love the radio range of the Nordic bluetooth chips. I am looking to see if anyone is developing a long-range bluetooth pendant or wearable? if so, I interested in perhaps...
I'm trying to read 8 adc channels using SPI, but then if I dont put some nrf_delay_ms the MISO return nothing and the CS is being driven low by default, high or a period of...
Does rbc_mesh_value_enable() API is designed for ? and how should I use it? and what does its parameter handle mean? Is it has the same meanning as the parameter handle of...
Hi,
I want to know is Liniux system supported Nordic BLE OTA DFU ? According to official documents： https://www.nordicsemi.com/Products/Development-tools/nRF-Util ，it just...
Hello community,
I am implementing BLE peripheral code contains, A custom service, characteristic.
I am referring this link : github.com/.../custom_ble_service_example...
Hello, nrf5340 datasheet -> nRF5340_OPS_v0.5
section: 7.1.26.7 Sending custom instructions (Page: 383) 1. we can send an instruction consisting of a one-byte opcode and...
I kind off trying enable TWI in bootloader mode, This is because of following reasons.
Firmware is stuck in bootloader, if somebody removes the Device Battery during...
Hi.
I'm trying to run an application using a custom SPM module in a nRF5340 where I get an error while running it. I'm using nRF Connect SDK. The terminal gives me this...
Hi
I have searched this question on the website before posting this and found that the nRF52 devices support SWD interface (which is peer to peer) and not JTAG (which...
Hello,
I was able to install all tools proposed by the nRF Connect v3.7.0 except the most important : Toolchain manager.
It retruns the following message
running...
Hi, I am interested in using the KMU and I have seen some examples of it here (9160 but similar): https://github.com/einarthorsrud/kmu_sample
and also some docmentation...
Aim: To upgrade the existing Bootloader + Softdeivce + Application package build using nrf_sdk_15 to nrf_sdk_17 on the NRF52840_DK.
Problem: I successfully flashed the secure...
We are using zephyr on that nrf52840 .
Is possible tu run code coverage analisys on that board ? What I have to do ?
Does twister work ?
Best Regards
Novelo G
My technical questions are as follows:
1) I need to upgrade an old iBeacon transmitter we design using the nRF52832 with SDK 11 (Sofdevice s132_nrf52_2.0.0_softdevice.hex...
