Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
SoC: nRF5340 SDK: nRF Connect SDK 1.9.1
CMAC calculation works fine with SDK 1.7 and SDK 1.8. But it failed with SDK 1.9.1.
psa_mac_sign_setup returns error = PSA_ERROR_NOT_PERMITTED...
Hi, I'm pretty new to microcontroller programming so please correct my wrongs.
I'm using the Libuarte driver library to have the pca10040 talk to my server via serial connection...
I want to use USB DFU + USB Audio <smp_svr + headphones_microphone>,
but I get an error when use USB to DFU, error log as below. How to fixed it?
*** Booting Zephyr...
Hi,
I've flashed the open thread rcp firmware(from samples) provided by Nordic SDK into the nrf52840 dongle. While running my application, I get the below response for the...
Is it possible to configure TWIM in smbus clock-frequency range (less than 100KHz)? I have created overlay file as follows for nRF52832 based HW, but it has no effect.
...
Dear support,
in nRF Mesh SDK each model can be configured to always publish segmented messages to improve reliability.
For example, the macro for the generic on off server...
Hello all,
I need to use fifo of my project with nrf5340. But there is always full when I put more data in.
Is there a way to make k_fifo bigger?
Thanks!
I have made a custom PCB based on nRF52810 SOC. I have started development on Segger Embedded Studio, SDK17.0.1.
I have flashed the GPIO example code to the PCB and it works...
Hi,
I didn't found the recommended max power supplye current on the datasheet,could you please help to tell nrf5340 max current consumption and t he recommended max power...
Good day,
I am currently developing a new product: "Bluetooth IoT Gateway" based on the nRF9160 SiP that would transfer data from a Bluetooth intelligent water level sensor...
Hello !
I have taken echo server sample as base (USB-NET and ipv6 only config )
and would like ti add border router ( if need ) and few static routes to other interfaces...
Dear Support Team
We would like to know how many RAM and ROM will be occupied by Network stack and WiFi host stack when use the nRF52840 or nRF5340 as a host for nRF7002...
Hi!
The project in question uses ncs 2.2.0 and Zephyr 3.2.99. The build is made through the VS Code ncs extension and the CONFIG_BOOTLOADER_MCUBOOT=y configuration is set...
Hey,
In the code below bt_conn_disconnect function is executed but the connection is still there. My goal is that peripheral is able to disconnect the connected device if...
Hi
I am using nRF5340 DK and nRF Connect SDK V2.2.0.
I have developed a BLE application code by using this custom_ncs_ble_service_sample tutorial. Its working fine.
...