Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
SoC: nRF5340 SDK: nRF Connect SDK 1.9.1
CMAC calculation works fine with SDK 1.7 and SDK 1.8. But it failed with SDK 1.9.1.
psa_mac_sign_setup returns error = PSA_ERROR_NOT_PERMITTED...
Hi, I'm pretty new to microcontroller programming so please correct my wrongs.
I'm using the Libuarte driver library to have the pca10040 talk to my server via serial connection...
Hi,
As seen in datasheet nRF52840 has one antenna Pin. We can connect either PCB Antenna or Ceramic or External Antenna. Is there a way I can use any RF switch to toggle...
Hi, I have been experimenting with an NRF5340dk for the past few days around the application of emulating a Mass USB storage device when connected to a PC.
I came across...
The error^^
Following the steps outline in this article to add MCUboot: https://devzone.nordicsemi.com/guides/nrf-connect-sdk-guides/b/software/posts/ncs-dfu
start with...
Hi,
I am building an app which has 7 central links and 1 peripheral link with PCA10040 DK board and S132. The central links look OK. But when I use the peripheral connection...
Hi There,
Environment Description:
1. nRF Connect for VS Code v2023.1.44.
1. NCS Version v2.0.0.
2. Zephyr v3.0.99-ncs1.
3. MCUBoot v 1.9.99
4. NRF52840.
5....
I'm working on a project that I need to write a file in the flash memory, but when I calling the function to open file (fs_open), the microcontroller crashes completely and...
Hello! Apologies if my ticket subject is a little unclear or if the terminology isn't correct. I'm currently trying to investigate an issue that causes my device to get stuck...
Hi, devzone,
I'm currently trying to flash the nrf52840 dongle from a custom IMX6-Ull board where it is attached and I'm also able to communicate and run the application...
Hi!
I am currently working on a project that involves taking a command sent over UART and broadcasting the data sent in that command to a number of BLE Mesh devices. I currently...
Hi,
I can't implement advertising on CODED PHY with primary advertising use PHY 1M and secondary advertising use CODED PHY on NCS2.1.1. Then I read the description about...
I am looking as using pwm and timers and trying to get them to use the HFXO rather then the internal RC as I need the higher accuracy. I know how to start it using the below...
Hi,
we found out after upgrading to SDK2.2.0 that sdc_hci_cmd_vs_zephyr_write_bd_addr does not accept a public bluetooth address anymore, this worked fine with SDK 2.1.0...