Hello
We need to scan for more than 8 devices, so we can't use witelist directly.
We have an idea to use presaved IRK and mac-addresses and use scanning without witelist...
Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
SoC: nRF5340 SDK: nRF Connect SDK 1.9.1
CMAC calculation works fine with SDK 1.7 and SDK 1.8. But it failed with SDK 1.9.1.
psa_mac_sign_setup returns error = PSA_ERROR_NOT_PERMITTED...
I know from the product specification for the nRF52832 chip that the high frequency clk can use a external 32 MHz crystal as source. My question is, is it possible to supply...
Hello!
I am now developing a product with NFC based on nrf52833.
I need to transmit some crucial data between device and phone, such as device settings.
But I have...
Hi all,
I would like to measure time intervals between gpio edges along with Matter.
I tried to use a 100us timer interrupt but seems it will crash the original matter...
Dear Support
I have made the following findings of my evaluation of the NRF5340 with Version 2.1.0 SDK:
-CIS mode has no constant delay at default settings 48-4. According...
Hello Nordic team,
I have looked at the BLE + Zigbee multiprotocol examples from nRF5 SDK and in these examples, I see that there is a file ' multiprotocol_802154_config...
Hello,
are NRF SoCs considered as BLE certified?
What is the default firmware in such case?
I guess no fw changes are allowed so that certification remains valid, right...
If I only wanted to allow one bond at a time, how could I do this?
For example when someone connects for the first time they would pair and bond, by entering the passkey...
Hello,
I am trying to use a blinky example from Nordic SDK (V17.1.0) as a starting point for our custom project. The device on our custom board is nrf52832 with 256k flash...
Hello,
We developed with nRF5240 using nRF5 SDK a zigbee coordinator.
We know that the stack is doing channel scan before forming the network to select the radio channel...
I want to be able to perform a DFU entirely from the netcore for backup/reliability reasons.
I can flash stream from the netcore to flash1 using stream_flash_init with ...
I try to establish a connection from nRFConnect Desktop using nRF52840DK to some hearing aid peripheral, but connection is immediately dropped after sending the first command...
Hello everyone.
I'm using the nRF Connect SDK v1.6.1 (it's an old project) on a nRF5340. Our project is based on the central_bas sample.
I want to use MCUBoot to update...
