Hello:
The latest nRF54L15 Errata for Rev 2 shows that the previously reported "GPIOs can exhibit radiated emissions" is no longer present in the Rev 2 SoC.
Can you please...
Hi, this is a very broad issue that i am having, because i dont know the source of it. I am simply unable to use the bme68x IAQ library. i have downloaded the external bsec...
Greetings!
I am using Wireshark along with an nRF52840 dongle to monitor BLE traffic between a mobile app and connected peripheral and periodically I see some "L2CAP Fragment...
Hello, I am using the nRF54L15 board, and trying to connect to the Adafruit SHARP 400x240 monochrome LCD display .
I got the display driver alone to function just fine after...
Hi,
I am trying to perform a DFU using SMP over BLE. My setup has NSIB and MCUBoot enabled and thus I am able to perform DFU for MCUboot and Application using nrf device...
Hi all,
I'm trying to use uart2 on my custom nrf9151 board, but I'm stuck. As I understand, I use i2c1 so I can't use uart1 and i2c1in parallel, so here is why I wnt to...
Hello,
I'm moving my project from SDK1.9.1 to SDK3.0.2. Project is based on peripheral_uart sample (UART part is removed since it is not necessary).
I have encountered...
Hello, I have recently updated our CLI backend to use LIBUARTE and it seems to be much more reliable. I have a few assumptions I would like to clarify and a few questions...
I am about to start new quite complex project with nRF52 and I thought that maybe it is high time to use freeRTOS port from SDK. As the device is going to be powered with...
We are experiencing some mysterious but very rare events of MCU going into system OFF mode. We are using nRF51822 and S110 v7.3.0. The wake ups are most likely caused by a...
Hi,
We are using nrf51822 QFAAH00 with SDK 110 v10.0.0 with softdevice 8.0.0 in our project, In Application we are using gpio,timer,uart interrupt handler, In main function...
Hi support team,
I'm using nrf52840 with softdevice 6.1.0 and sdk 15.0. I started from the ble_connectivity example as my central and used pc-ble-driver on my host PC as...
Hi,
I´m looking for a Bluetooth low energy proximity sensor with this (or similar) characterisics:
One main (receiver) module and many secondary (transmitter)...
I'm using a custom board based on the Thingy52 board and firmware that uses the BMD-350 module containing the nRF52832.. I'd like to use the internal RC oscillator for the...
Hi,
I just found out that the scanning procedure does not time out in SDK 15. This is because in SDK 15 we are forced to restart the scanning procedure everytime an advertisement...
I am using nRF5 SDK for Thread and Zigbee 2.0.0
I am having trouble commissioning using NFC, either with the nfc_meshcop example or my own code (based on the nfc_meshcop...
Hi we are trying to test the serial boot loader example from sdk 11,sdk 12.03 non of them working while running using nrf go studio it says enter in dfu mode and while we...
Hi, I want to use the p0.18 as a GPIO without being connected to nRESET function. So I removed "CONFIG_GPIO_AS_PINRESET" from the define option in Keil. And then i found that...
Hi there,
due to unknown reasons, my nrf52840-DK (1.0.0) didn't come back up after flashing software to it. Means the LED that usually turns on when you power it up remains...
