I am using MX25 external flash with nRF9160. I am unable to find the configuration to use the Zephyr APIs to access the flash. I am able to access it when I am using
spi_write_dt...
Attribute reporting is automatically handled by the ZBOSS stack which generates the Report Attribute commands. Is it possible to set the Disable Default Response bit in the...
Hi all,
I've followed the instruction to setup nRF sniffer with Wireshark.
But unfortunately, I see this error when I'm trying to start a new capture with my nRF Sniffer...
Hi
I tried to run the sample "hci_pwr_ctrl" from the NCS v2.7.0 on the nRF54L15.
After starting the sample, the modification of the TX power level during the advertising...
Hi,
I realise this is now quite an old version of the SDK and this particular library is no longer supported, but we have not yet migrated our project (I did try once...
I'm using the nordic ppk II to measure the power consumption of my device.
In order to validate the charge (current integral) displayed by the PPK2 i put two PPK2 daisy...
Dear all:
I have viewed that matter support below Operating Systems from this link:
project-chip.github.io/.../BUILDING.html
Tested Operating Systems #
The build...
Is it possible to route a signal derived from internal clock to an IO pin? I am new to NRF micro controller. My experience has been with Cypress PSOC and in the IDE it was...
Hello,
I have an nrf52833 that interfaces with an external flash module. It is configured to store mcuboot's secondary partition. I am able to write the secondary image...
Hello All,
I am attempting to use the scanning module to scan with a filter. Right now I am trying to implement a short name filter.
I am using the nrf Connect extension...
Hi,
I am trying to use a Modbus(TTL to RS485) converter to work with Nrf52832.
I am using rtu_client ( https://github.com/zephyrproject-rtos/zephyr/blob/main/samples...
Hi,
I'm evaluating a scenario of using an nrf9160 with an HMI, communicating via modbus tcp connection.
The hardware setup looks like this:
HMI <-----> Ethernet switch...
Hello,
I am having a strange problem with nRF Connect SDK for VS Code, and would appreciate some help.
I don't know what I did, but suddenly I am not able to "Generate...
Dear All,
I am trying to use sscanf in a project and I am getting the message that it is undefined. I am including <stdio.h>.
I cannot understand/find the reason of...
Hello everyone,
I'm taking the "Bluetooth Low Energy Fundamentals" course For all the examples I followed in the training, from what I understood, we loaded the peripheral...
Hello, we are trying to use the shell over bluetooth but in default it also uses the uart contorroler of the board. us there any configuration option to disable the zephyr...
I have not messed around with devicetree much before this point. I'm trying to create a custom dts and bindings for my device. Within my custom dts file, I reference the nRF52833...