Hello,
I have a device based on nRF51822 revision 2 and SoftDevice S110 v7.1.0. Because it is revision 2 it is affected by PAN44 and PAN45, and by default the SoftDevice...
Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hi,
I'm working on a project using BLE via s140, everything works fine until I look more seriously at the current draw of the device.
Simply, my project starts a Scan...
Hi,
I was able to get the DFU system working by CONFIG_BOOTLOADER_MCUBOOT =y. I notice that the default mcuboot update methode is using the scratch partition. According...
Hi,
We use the SKY66112 FEM in front of nRF5340. The FEM is configured in the DTS file. On our ordinary firmware, the TX pin is set and reset automatically. I can see...
I am trying to build a new workspace for my project using VSCODE & nrf connect. I select create new application and fill out the config as seen in attached photo. The build...
Hi connection,
I am trying to build indoor position system, Find the location, Find the direction and Distances project. can you suggest it is possible in NRF5340DK ?
...
I noticed in the nRF extension in VS Code, there are the "pristine build" and "erase and flash to the board" options. I was curious when I should use these options instead...
Hi,
I am currently programming an nRF52 device with the NCS - I am confused about the API for the Zephyr controller, the API for the Bluetooth controller, and the Softdevice...
Hello,
I have the nrf9160 DK version nRF9160 SICA B0A. I have upgraded it to the latest modem firmware version 1.3.2.
I put my own SIM card and added in prj.conf the following...
Hi, I now aply ble_app_uart example for my custom board My board work perfect Some configurations in my code based on ble_app_uart Advertising_interval : 64ms Tx: 0 Some changes...
I am trying to get the example secure bootloader uart working on my nRF52832 development board but I am seeing a lot of TX errors on the RTT log output from the debug version...
Hello everyone,
I have built a product with the nRF52840 that is ready to be manufactured. Connect JTAG/SWD and upload image to each board seems grossly inefficient. Is...
Good day
I am currently developing a system using the nRF52833. A nRF peripheral device needs to be connected to both a mobile app and a nRF central device. The software...
I'm working on an Android app that scans and makes BLE connections. The app scans for devices advertising a particular service. The app uses startScan with a PendingIntent...
