Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi!
I'm trying to configure my NRF8001 module with the help of nRFgo studio. I'm using Nordic UART over BTLE service template. The module can be discovered via nRF Master...
Hi, I need help with a simple example code to read analog pin 5 and either control brightness of the LED or print value on terminal. I found this example but it didn't work...
Hi nRF Team,
I would like to know more detailed operation of LE audio profile on nRF5340.
My requirement is to continuously process PDM mic ( PCM data ) interfaced to...
Dear all, in my company we started to product custom pcb with nrf52833 for networked lighting control (NLC).
For the firmware, we had a look to the examples provided with...
Hi,
we have got some async uart api application running with zephyr 3.2 on nrf52840.
This worked fairly well until there have been added some file-write operations to...
Using the zepher spi driver (which wraps nrfx) on ncs v2.6.1, the CS line goes low to start the transaction, then high about 10 us later, but the data keeps coming out.
...
I am using nRF52832 and Nordic connect sdk. I want filter scan for the beacon having specific uuid. I have programmed the dk with this code
The serial terminal is showing...
Hello,
Our nRF52833 is powered through a load switch and control when to enable it is based on external peripherals logic. The MCU is connected to external peripherals that...
Hello,
I am contacting you because I no longer have the "Enable Debug Options" option when I edit my Build Configuration.
I uninstalled and re-installed the nrf Connect...
Hi. I am trying to build/flash a sample with nrfConnect and vscode. When I add a build configuration, I face following issue :
-If the output build directory is "build/something...
Hello,
I noticed that our self-produced PCB's with a nRF5340 SoC all have the cores locked upon delivery (probably app protect is activated), and have to be recovered before...
I'm using ncs2.6.0 to develop a door lock project for matter, and I'm running into a problem: I need to store some user-set parameters in the project, which take up less space...
I am looking for a good document to establish an I2C connection between the nRF5340 and another microcontroller. I am using VS Code and the Nordic SDK. Unfortunately, the...
compliler enviroment is NCS2.6.0, zephyr/sample/bluetooth/peripheral_hids run in nrf52dk_52832 board.
use mobile, the <nRF Connect> app can connect the BLE board.
but...
Hi community,
I`m trying to develop a custom board with nRF5340, now comes the question how to flash it?
The application was developed with the Thingy53. On Thingy53 the...