Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
I am getting starting the nrf52832 board with an LSM6DSL sensor for motion recognition. it is possible in edge impulse ??
how to configure the firmware Development and how...
Hello.
I am developing a central operation using nrf52832 (S132 v7.0.1, SDK v17.0.0).
When making a BLE connection, you will receive an advertisement first. Then SCAN_REQ...
Hi Nordic,
I try to find an API to set the duplicate filter when scanning. But I found nothing.
I want to use the dulicapte filter disable feature to improve searching...
Hi. I've been working on getting a gsm modem functional using the GSM Modem Zephyr driver on an nRF5340. I believe I have the overlay file setup correctly, but am recieving...
Hi
I known that for NB IoT networks, a device can only be attached and separated 30 times in 1 hour. If the number exceeds the number of times, the modem will have to wait...
I'm using nrf_delay_ms in main on "ble_app_beacon", but the delay time is much longer than I set.
I have set 2000ms delay to log, but it seems 4s or longer than I set.
Hello,
I am able to get a successful confirmation that my application has been updated using the nordic secure bootloader over serial code example. However, my application...
I'd like to both use printf and NRF_LOG in my application. However, I have not been able to get both working simultaneously. Is this possible?
I init the logging like: ...
Hi,
Please help me deal with the problem that P0.26 IO port is invalid as a key
I connected the P0.26 port to GND and used SES simulation to see the following results...
Hello,
i have an issue with i2c on my nrf52840 dk. I attached the distance sensor vl53l1x to pin 27 (SCL) and 26 (SDA) and wanted to communicate via i2c with it. To test...
Hello
I have an application running which boots up fine.
I've written a bootloader which boots up first, and then jumps into the application including softdevice.
So...
I am trying to implement a TCP server with TLS support. I have the following confusion-
Do we need to use mbedTLS API explicitly or is it internally handled by a zephyr...
Hi,
I am developing a simple application where I read some data from a sensor, and publish the data with MQTT. I want to use PSM to conserve battery life, and I am able...
