Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Hello,
I try to modify the lpcomp example from the Nordic SDK to trigger the sampling of the lpcomp manually. I have added the following code:
I use AIn3 (GPIO 5) as...
Hello,
I'm using Zephyr SDK. I have got BLE characteristic (my device is a peripheral) with following settings:
After successful write operation, I want to reply with...
Hi,
I'm trying to build the peripheral_lbs sample app for the nRF5340 using VS Code and I cannot get past the build configuration stage. Any assistance would be appreciated...
Hi.
I´m trying to install the application asset_tracker_v2 on my nRF9160DK ver 0.9.0 board.
I´m using VS code and during the build i got errors.
"too few arguments in...
Is there any good tutorial about the Android-BLE-Library Nordic library ?
I have only found the examples, but you need to dig in the code to learn how to use.
Greetings,
What are the settings to allow an nRF52811 to use CODED PHY with the NCS peripheral_hr_coded sample?
NCS v1.7.0
board = ubx_bmd360eval_nrf52811 (effectively...
Hi,
nordic tearm,im use nrf52840 develop a ble hid keyboard,my description of report like this :
my send api like this:
my consumer key like volume add and reduce...
Hello,
In the document about Release assistance indication %RAI. It says
In addition to using the %RAI command, the application must tell when the data connection is...
Hi,
I was using NCS 1.5.0 and Modem firmware 1.2.3.
I have latest DK of nRF9160.
It was running properly without issue specially LTE connection.
But after I migrated...
Hello,
i ran nRF Coap Client and it worked pretty well.
I am working with nRF9160 DK.
Now, I want to add DTLS to this example to secure the data.
Can someone please...
Hi.
I wasn't sure under what topic to post this but it's just a generic question I suppose. I'm still learning so please give it to me in plain English.
It took me a while...
HI Nordic,
As far as I know, in nRF5SDK, the maximum link number of BLE is 20.
I search for the devzone, someone said the number for NCS is 64.
So, I want to know: ...
At multiple places in the SPM subsystem code incorrect assumptions regarding the SRAM memory layout are hard-coded:
At line ~35:
This code is enabled when USE_PARTITION_MANAGER...
