Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hello!
I recently purchased a RedBearLab nRF51822 board where I want to use several DS1820 temperature sensors.
For dealing with the OneWire (1-wire) protocol I found...
Hello,
I'm not sure if this was already asked before. I didn’t found a similar question, so here it is: When I have a function that manipulates a data structure to communicate...
In this ADC example from Nordic on GitHub, it does not appear an AIN has been selected (e.g.: no call to nrf_adc_input_select() ). I don't understand. I have been assuming...
Hi,
I am creating a central application on a Nordic nRF51 device. Our project is related to connecting to peripheral of any profile. Using the MCP I connect, bond and enable...
Hello,
For our application I have to set up two simultaneous connections between a S120 master device and two peripherals that use the S110 softdevice.
A very short connect...
Trying to send 3 20-byte packets of data from nRF51822 (peripheral device) to a Samsung Galaxy S5 (central device) and send 1 20-byte packet back, all in less than 10ms. I...
Hello,
I'm looking to bootloader sources and i want to add a timeout if entering with a signal in DFU mode and no DFU detected for one hour.
There is a timers_init function...
I have a project that requires full-duplex voice comms (doesn't need to be high-quality). I'm evaluating the suitability of BTLE for the task. The new nRF52 has a PDM module...
I'm moving to Nordic from "another" BLE s.o.c. where the UUIDs, profiles, services and characteristics were defined in XML. With that product I could modify or examine or...
Hi
In nRFgo Studio there is an option to read the entire memory of a chip. In my case nRF24Le1 to a .mhex file.
The first lines of the .mhex file says:
Infopage:
Identifier...
