Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi all,
I would like to measure time intervals between gpio edges along with Matter.
I tried to use a 100us timer interrupt but seems it will crash the original matter...
Dear Support
I have made the following findings of my evaluation of the NRF5340 with Version 2.1.0 SDK:
-CIS mode has no constant delay at default settings 48-4. According...
Hello Nordic team,
I have looked at the BLE + Zigbee multiprotocol examples from nRF5 SDK and in these examples, I see that there is a file ' multiprotocol_802154_config...
Hello,
are NRF SoCs considered as BLE certified?
What is the default firmware in such case?
I guess no fw changes are allowed so that certification remains valid, right...
If I only wanted to allow one bond at a time, how could I do this?
For example when someone connects for the first time they would pair and bond, by entering the passkey...
Hello,
I am trying to use a blinky example from Nordic SDK (V17.1.0) as a starting point for our custom project. The device on our custom board is nrf52832 with 256k flash...
Hello,
We developed with nRF5240 using nRF5 SDK a zigbee coordinator.
We know that the stack is doing channel scan before forming the network to select the radio channel...
I want to be able to perform a DFU entirely from the netcore for backup/reliability reasons.
I can flash stream from the netcore to flash1 using stream_flash_init with ...
I try to establish a connection from nRFConnect Desktop using nRF52840DK to some hearing aid peripheral, but connection is immediately dropped after sending the first command...
Hello everyone.
I'm using the nRF Connect SDK v1.6.1 (it's an old project) on a nRF5340. Our project is based on the central_bas sample.
I want to use MCUBoot to update...
when i build the radio_test(path:v2.1.2\nrf\samples\wifi\radio_test),and flash to the nRF7002PDK,but the code is not runs smoothly .the following is the program log.
[1;32muart...
Hi,
my PC stopped detecting the JLink debugger on my NRF52840DK board. This happened after I accidentally flipped the NRF only switch while I was handling the board.
I...
