Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi!
I'm trying to configure my NRF8001 module with the help of nRFgo studio. I'm using Nordic UART over BTLE service template. The module can be discovered via nRF Master...
My customer looking for very low power solution for their project. It's not reuired fast answer of node in network or permanent connection with each device. Just a rarely...
Is it possible to talk TCP/IP over BLE on nRF52810 (similar to PAN profile on BT classic)? Can SD S112 fullfill this or would S132 be needed. I know memory needs are an issue...
HI.
I use BLE in observer role. I register event handler only ones in initialization: NRF_SDH_BLE_OBSERVER(m_ble_observer, APP_BLE_OBSERVER_PRIO, ble_evt_handler, NULL);...
I am using the secure_bootloader to perform firmware updates via USB on the nRF52840 (custom board). This works great when I start with no application (only bootloader and...
Hello,
I am developing product on nrf52 with sd s112_nrf52810_5.1.0_softdevice. My application caused unexpected sd fault at adress 0x000089B2. I expect it to be something...
Hi Great Nordic Support Team:
Our client is going on the project with capsense touch sensor.
They're wondering about if there is any reference design about it.
Any...
Is it possible to use the timers in components/nrf_drivers/timer along with softdevice s132? If I enable the softdevice by calling softdevice_enable() my application restarts...
Hello,
My nrf51822QFAAH2 doesn't start, I mean that when i plug it, i can't see any Bluetooth device on my mobile detected, maybe I am missing a step, I don't know,
Here...
Hi.......
i am student , i am doing a project based on temperature. i want transfer data from temperature sensor to phone via using NRF connect . can you help me ? how to...
How send the larger data,which is more then 300 bytes in spi master example.i am using the Sdk 15.0.how to enable the spi .please send the default pins used for the spi.
Above is the "inverted—F" PCB antenna referenced.Below is the RF SCH and PCB layout,the PCB diameter is 20mm.Chip we use nrf51822 and bal-02d3.
Can the antenna work...
Playing with the logging and cli commands for logging, I normally get this if all my modules are lowercase named (but also if they are alfabetically after CLOCK):
It seems...
I have met a problem, that I can't download the previous version of nRF5 SDK, like 15.0.0, but only the lastest,15.2.0. Because a lot of work of mine is based on version 15...
I have successfully built and run the mesh examples 2.2.0, on several nrf52832dk boards with the exception of the EnOcean Switch example.
I can successfully build and launch...
