Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hello,
We're looking for easy way to communicate between nRF51822 configured as central part with C# application.
Ideally we should use standard firmware which forwards...
Hi,
Im trying to monitor the high voltage im generating with PWN using ADC. I also need to run BLE at the same time to provide results.
So far I dont have any luck and...
Hi,
Why you use a Hex format file for the firmware with a Toolbox Android, then the IOS Loader you use a binary format file ?
Because I would like use the same file. ...
I have a nRF51822 and arduino uno board. Is it possible to connect my nRF51822 uart to the arduino rx/tx, so that i can use it for communication to PC through arduino. The...
I'm having some problems when flashing the mbed enabled nRF51 kit. This is currently my environment:
When I try to download the file I always get this error: "Cannot Load...
Hello all,
I have two services which has characteristics with indication only property. I am using sensor simulator to generate values. When i write first CCCD write of one...
Hello,
I have been searching for GPIO documentation, particularly on interrupt configuration, and I have come up short. Can someone send me a link where I can find more...
As we know, there is a solution of wireless charging in nordic. I just want to know where is the Bluetooth stack in the solution? In SOC or in Bluetooth controller? If In...
Hello,
I am using nordic development kit nrf51822 and i was trying some examples of it as given. But in that in one example there is one function
static void gpiote_init...
I am aware that the debugging interface draws significant current, I do not believe that is the case.
I have 2 designs in front of me. Let's call them '2.0' and '3.3' ...
Hi
I'm a little confused with the RAM usage with S110 support, the following represents the memory usage of example of "ble_app_template", even there is no any application...
Hi,
i want to know
how to sink mobile and softdevice in BLE or WIRELESS(having 4.0 stndrd)?
how to send BCON from nrf51288 board in order to set connection with...
Hello,
We have started down the path of getting our first Bluetooth Smart product through the Bluetooth qualification process. We are using the nRF51822 with SDS 6.0.0...
