I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi community,
For debugging / a project in very early stage I need to sniff Thread packages and (later on) Bluetooth (LE) and ZigBee packages.
I would like to use the...
After reviewing the add DFU support to your application guide
i have several questions:
1)What modifications are required for the nRF5340 with an app core and net...
We are using SDK15.0.0 and have products with both the NRF52832 and NRF52840 sharing the vast majority of code between them. The softdevices we use are S132 and S140 at version...
Hi,
The nRF52840DK-2.0.1 is not working/turned on.
it works intermittently, and keep on connect/disconnects continuously after sometime.
I suspect the SW9 switch is...
Hi,
is there a way to send some status data from the headset to the gateway in the nrf5340_audio application?
We would like to monitor the battery voltage of the headset...
I'm trying to go through the proes and cons of a Hosted Vs Hostless Solution for BLE using the nRF52840. I have an AP thats running a stripped down version of Linux. Currently...
Dear Engineer,
Working on sdk17.1, hrs free rtos demo. chip nrf52832, on pca10040 board.
From Sdk 17.1, log not resume in application hook to save power.
Use log_pending_hook...
I use the PPK2 to measure the power supplied from a lithium polymer battery to a test device. I use 'Ampere meter' and the 'Enable Power Output' switch in the UI then 'start...
Hello,
I am using SoftDevice S140 SDK 7.2.0. I need to initialize the no init parameters.
For doing that I used nrf_power_resetreas_get() return parameter. Two questions...
Hi,
The memory space of the application core for nRF9160 is empty.
Now,if I set the ERASEPROTCET register located in the UICR to 0( Erase protect will be enabled.), how...
