I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
hi,
I try to realize all parameter functions in the peer manager. ( I use SDK 15.2.0 )
I expect to design is bond total max 4 in the product. I have some question in below...
Hello,
I'm working on NRF9160-DK. I would like to be able to put the card to sleep in the deepest sleep possible to be able to save as much energy as possible and to wake...
Hi to community again!
I'm having trouble with TWIS during page erase on nRF52840 (FICR "Read 4 bytes @ address 0x10000104 (Data = 0x41414330)") as the bus is stalled...
Hi,
I'm using SDK 17.0.2 on NRF52832
I'm getting an error "undefined reference to `__RAM1_segment_end__'" in "Output/<name>_Debug/Obj/ses_startup_nrf_common.o: in function...
Hi Lorenzo,
I have gone through most of the documentation related to Immutable (SB or b0), McuBoot and application and i have the following queries:
which one should...
Hi,
1) i try to build the eddystone sample program and it prompt "....missing micro-file......".
2) i went support site and search thru some recommendation.
3) After...
Hi all,
Download and build SDK excample in MDK, fail!
Error #543: Device nRF52840_xxAA(Nordic Semiconductor) not found, pack 'NordicSemiconductor.nRF_DeviceFamilyPack_NordicLicense...
I'm using the PCA10056 with a SD card connected via P1.12-P1.15.
When i use the FatFs example of SDK13.0.0, it's works fine. but when i use the FatFs example of SDK14.0.0...
Hi,
We are trying to connect to NB-IoT network but seems nrf9160 not able to connect. We are trying with an NB-IoT SIM in Malaysia. Below is the log captured using LTE Link...
I want to change DLE/MTU in udp (IoT) example in order to test throughput with max mtu, is it possible?
The udp example does not contain nrf_ble_gap library, is it possible...
Relative newbie here. Would like to interface an Arduino MCU (AVR 328p/32u4, etc) via UART protocol with a decent range (50-100m open air) nrf 52840. I found the Fanstel BT840F...
