I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hello,
I am able to get a successful confirmation that my application has been updated using the nordic secure bootloader over serial code example. However, my application...
I'd like to both use printf and NRF_LOG in my application. However, I have not been able to get both working simultaneously. Is this possible?
I init the logging like: ...
Hi,
Please help me deal with the problem that P0.26 IO port is invalid as a key
I connected the P0.26 port to GND and used SES simulation to see the following results...
Hello,
i have an issue with i2c on my nrf52840 dk. I attached the distance sensor vl53l1x to pin 27 (SCL) and 26 (SDA) and wanted to communicate via i2c with it. To test...
Hello
I have an application running which boots up fine.
I've written a bootloader which boots up first, and then jumps into the application including softdevice.
So...
I am trying to implement a TCP server with TLS support. I have the following confusion-
Do we need to use mbedTLS API explicitly or is it internally handled by a zephyr...
Hi,
I am developing a simple application where I read some data from a sensor, and publish the data with MQTT. I want to use PSM to conserve battery life, and I am able...
Hello,
I am using a nrf5340DK to test the BLE Central sample of Zephyr.
As a BLE peripheral I am using a nrf52840 dongle. I have it configured via nrfconnect SDK - Bluetooth...
Hello,
I try to modify the lpcomp example from the Nordic SDK to trigger the sampling of the lpcomp manually. I have added the following code:
I use AIn3 (GPIO 5) as...
Hello,
I'm using Zephyr SDK. I have got BLE characteristic (my device is a peripheral) with following settings:
After successful write operation, I want to reply with...
Hi,
I'm trying to build the peripheral_lbs sample app for the nRF5340 using VS Code and I cannot get past the build configuration stage. Any assistance would be appreciated...
Hi.
I´m trying to install the application asset_tracker_v2 on my nRF9160DK ver 0.9.0 board.
I´m using VS code and during the build i got errors.
"too few arguments in...
