I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hi,
We are using nRF connect SDK for developing the BLE Mesh application.
We want to use a sample application and modify the folder structure based on our requirements...
According to nRF51822/nRF51422 PS v3.1 table 34, current consumption can be decreased by executing code from RAM instead of from flash. How is it possible to execute code...
I found Note declaration at nRF52840_PS....pdf.
The Note is that "Do not enable DC/DC regulator without an external LC filter being connected as this will inhibit device...
Yesterday, 7th April 2021, Apple officially rolled out support for their 'Find My' network to third parties.
https://www.apple.com/newsroom/2021/04/apples-find-my-network...
Hi,
Using the below configuration settings "add new project " settings was enabled on UI but after compilation setting changes was reverted could you please suggest how...
Dear support team:
The customer says that the Bluetooth SIG Qualification Test requests the PICS & PIXIT parameters of nRF52805.
Could you have the PICS & PIXIT parameters...
I want to implement usb mass storage using FAT FS, However there is problem when is build the solution using this command line:
west build -b nrf52833dk_nrf52833 samples...
Hi,
I am using NCS SDK 1.6.1 want to create an executable over the NCS SDK static libraries
could you suggest concrete approach how to import the functions from the static...
Hi,
I am using nRF52832 development kit to connect to STM32L4 via UART. I flashed ser_s13 2 _uart binary to nRF board and porting the STML0 nRF driver package from here...
Hello Nordic team!
We are developing system on nrf52832 chip. Let me describe our system a little bit.
It is constructed out of the soft device 332, main application...
Hi
We are using nrf mesh Android code from GitHub and trying to get shared secret during the Provisioning Public Key PDU Process.
We are getting following error -(We are...
Dear friends,
I am not sure if it's the right platform to be asking this question but I thought this would be the place where I would find like-minded individuals. I am...
In the nRF SDK 15.2, I am using the function idle_state_handle() which has a macro NRF_LOG_PROCESS() which is defined in another header file as NRF_LOG_INTERNAL_PROCESS()...
