Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
I am looking to migrate to SDK 8.1 and S110 V8.0 and going through all the implications of that move. One key one is the current Bug with Radio Notifications on S110 v8.0...
Hi everyone,
I am a new here~ If I asked some stupid question, please easy on me.
Currently I am doing a prototype with nRF51822 chip. I know that the official programming...
What is the purpose of the TWI overrun flag given that the TWI peripheral only supports master mode?
I have the following code in an ISR for my TWI acting as master.
...
Hi guys. I have a nRF51822 reference design board which is based on low voltage mode circuitry (using 1.8V supply directly). However, my Segger Jlink (SWD) does not work while...
By default, S110 advertises in all three advertisement channels. I need to limit the advertisement channels, so that I can advertise on a single.
In a similar question...
I now this are basics. And I did this allready a few times, but in this project it simply wont work.
Maybe someone of you will find something, that is missing.
I`m working...
Examples like the "proximity application" are all associated with the nRF51422_xxAC. The part I'm using is the nRF51822_xxAA. How do I make this examples work with my part...
Hi,
I am wondering what to do to fix the error I have been getting while trying to debug my project. I am using app_trace for logging. I would often get an error on the...
I have a custom PCB with nRF51822. I have copied the "QFAA QFN48 with internal LDO setup" schematic from Product Specification v3.1. However, I have not copied the PCB layout...
Hello,
I am using a custom PCB with ISP130301 BLE module based on nRF51822. The PCB layout for the module is designed based on the recommended PCB land pattern and solder...
Hello,
yesterday i ordered th nrf52 Development Kit an just had a look in the Errata infocenter.nordicsemi.com/index.jsp So if i get my Development Board, will all this...
Hi,
I've read posts showing programming the Beacon with nRF51-DK using the debug-out port. As the nRF52-DK is available right now, does anyone have any idea if I can use...
