I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
hi，dear.
I designed the hardware according to the datasheet of NRF52832, version 1.4, Page 545,Figure 169: QFAA and QFAB QFN48 with internal LDO setup.
In the picture...
Does anyone know of any current Apple devices (and a supported iOS version) that support extended advertising? I'd like to download the nRF Connect app on an Apple device...
SDK 15.3.0; nRF52832
In a previous discussion about continuing to advertise while connected:
[quote userid="4240" url="~/f/nordic-q-a/45644/how-do-i-simply-do-a-non-connectable...
Hi,
I've developed firmware for nRF52832 to beacon and scan for identical beacons. So with many devices, each can detect the others. What I've noticed is that while most...
Hi,
I am using the Zigbee CLI to maintain and control a Zigbee network. The Zigbee stack is running on a BMD340 module. I added a Ikea Trådfri dimmable light bulb (only...
Hello,
I'm developing a coin-sized board based on the nRF52840 and the nRF52833 in aQFN73 package. The PCB has only two layers with the bottom layer dedicated to ground...
I saw that in SDK there are examples with tcp, dhcp and etc of iot. If some router have usb port, is it possible somehow to configure nRF52840 as part of network infrastructure...
Hi All
I am using nRF9160 and read a value from Fuel Gauge IC (LC709203f) via I2C so I use i2c_scaneer sample
so I just a little bit confused what should I change in...
According to the nRF52832 spec, the flash memory can handle a minimum of 10K write/erase cycles. I need to understand the following:
I understand the write/erase cycles...
Hi team,
We are using Raytech nrf52840 dongles as NCP connected through USB to RaspPi compute module. We would like to upgrade the NCP application in the field using DFU...
Dear nordic,
I have an application that developed using development kit pca10056. I want to change it to supporting nRF52811. I want to test the long-range feature of nrf...
Hello. I'm a CS student and I've bought myself two NRF52840 Dongles. I've downloaded NRF Zigbee SDK and wanted to flash and try out some examples. But the simplest light_control...
